This paper presents a 2.5 Gbps 10-lane low-power low voltage differential signaling (LVDS) transceiver for a high-speed serial interface. In the transmitter, a complementary MOS H-bridge output driver with a common mode feedback (CMFB) circuit was used to achieve a stipulated common mode voltage over process, voltage and temperature (PVT) variations. The receiver was composed of a pre-stage common mode voltage shifter and a rail-to-rail comparator. The common mode voltage shifter with an error amplifier shifted the common mode voltage of the input signal to the required range, thereby the following rail-to-rail comparator obtained the maximum transconductance to recover the signal. The chip was fabricated using SMIC 28 nm CMOS technology, and had an area of 1.46 mm². The measured results showed that the output swing of the transmitter was around 350 mV, with a root-mean-square (RMS) jitter of 3.65 ps@2.5 Gbps, and the power consumption of each lane was 16.51 mW under a 1.8 V power supply.

The equalization of a large attenuation signal and multirate communication in high-speed serial interface is hard to balance. To overcome this difficulty, an adaptive equalization system with optimized eye-opening monitor is proposed. The designed eye-opening monitor is based on the asynchronous statistic eye diagram tracking algorithm, and the eye diagram is obtained by undersampling with the low-speed asynchronous clock. With the eye-opening monitor into the adaptive loop, an adaptive equalization system combined with continuous-time linear equalization (CTLE) is completed. And the inductor peaking technology is used to improve the capacity of compensation. With SMIC 28 nm CMOS process to achieve the overall design, the power consumption and core chip area are 12 mW @ 12.5 Gbps and 0.12 mm², respectively. And postsimulation results show that it can offer compensation from 6 to 21 dB for 1.25–12.5 Gbps range of receiving data, which achieves a large range of data rate and channel loss, and its power efficiency is 0.046 pJ/bit/dB for the worst case, which is better than most previous works.

This article presents a low power digital controlled oscillator (DCO) with an ultra low power duty cycle correction (DCC) scheme. The DCO with the complementary cross-coupled topology uses the controllable tail resistor to improve the tail current efficiency. A robust duty cycle correction (DCC) scheme is introduced to replace self-biased inverters to save power further. The proposed DCO is implemented in a Semiconductor Manufacturing International Corporation (SMIC) 40 nm CMOS process. The measured phase noise at room temperature is −115 dBc/Hz at 1 MHz offset with a dissipation of 210 μ$\mathsf{\mu }$W at an oscillating frequency of 2.12 GHz, and the resulin figure-of-merit is s −189 dBc/Hz.

This paper proposes a hybrid dual path sub-sampling phase-locked loop (SSPLL), including a proportional path (P-path) and an integral path (I-path), with 0.8 V supply voltage. A differential master–slave sampling filter (MSSF), replacing the sub-sampling charge pump (SSCP), composed the P-path to avoid the degraded feature caused by the decreasing of the supply voltage. The I-path is built by a rail-to-rail SSCP to suppress the phase noise of the voltage-controlled oscillator (VCO) and avoid the trouble of locking at the non-zero phase offset (as in type-I PLL). The proposed design is implemented in a 40-nm CMOS process. The measured output frequency range is from 5.3 to 5.9 GHz with 196.5 fs root mean square (RMS) integrated jitter and $-251.6$ dB FoM.