Ultrasonic wave carries the information for flowing velocity when it is propagating in flowing fluids. Flowrate can be obtained by measuring the propagation time of ultrasonic wave. The principle of transit-time ultrasonic flowmeters used today was based on that the velocity is uniform along the propagation path of the ultrasonic wave. However, it is well known that the velocity profiles in a pipe are not uniform both in laminar flow and turbulent flow. Emphasis on the effects of velocity profiles across the pipe on the propagation time of ultrasonic wave, theoretical flowrate correction factors considering the real velocity profile were proposed for laminar and turbulent flow to obtain higher accuracy. Experiment data of ultrasonic flowmeter and weighting method are compared to verify the proposed theoretical correction factors. The average relative error of proposed correction factor is determined to be 0.976% for laminar flow and 0.25% for turbulent flow.
TC18 titanium alloy has been widely applied, but is considered as a difficult machining material. Taking the kerf angle as the quality criterion, this paper studied the cutting performance of TC18 by the use of an abrasive slurry jet (ASJ), based upon multivariate nonlinear regression and SA-BP-AGA. Cutting experiments were carried out according to the Taguchi orthogonal method. The experimental factors included traverse speed, standoff distance, pressure and slurry concentration, with five levels set, respectively. Meanwhile, a characterization method of the major influencing factors was proposed. A multiple nonlinear regression model and a back propagation artificial neural network (BP) prediction model, based on adaptive genetic algorithm (AGA), were established. The reliability was verified by statistics equations for the 22 groups of the fitting or training model and the three groups of experimental results. The BP-AGA and Simulated annealing algorithm (SA) were used to form a set of prediction optimization systems, called integrated SA-BP-AGA. Finally, the results showed that the main factor influencing the kerf angle is the slurry concentration. BP-AGA is easier to model, offers better robustness and is more accurate than a multivariate nonlinear regression model. The best kerf angle can be predicted by the integration system. The study results can improve the performance for the machining of TC18 by ASJ.