The strengthening and ductilization of steels are of great importance to weight reduction of vehicles. In this work, the strength–ductility synergy of dual-phase (DP) steels was obtained by properly tailoring the structural heterogeneity, including the distribution and fraction of constituent phases. It was demonstrated that heterogeneous structural DP steels with high volume fraction of martensite (from 64 to 83%) led to a good combination of strength and ductility. Compared with the cold-rolled sheets, the tensile strength and uniform elongation of heterogeneous DP steel increased by 700 MPa (from 1.06 to 1.76 GPa) and 2.7% (from 1.3 to 4%), respectively. The contributions from back stress and effective stress were analyzed by cyclic loading–unloading experiments. The underlying deformation mechanism was discussed based on the results of mechanical test and microstructure observation.
Mg–Gd based alloys are typical high strength magnesium alloys owing to their outstanding age hardening behavior. The mechanical strength of aged Mg–Gd alloys is enhanced by high density prismatic-shaped precipitates in Mg matrix. Moreover, the addition of Ag has been found to enhance the strength of Mg–Gd based alloys further by forming a plate-shaped precipitate, named as γ″, on basal planes of Mg. However, the structure of this precipitate is not well understood due to the complex alloying system. In this work, the atomic structure of γ″ phase is investigated using atomic-resolution high-angle annular dark field scanning transmission electron microscopy (HAADF-STEM). Based on the accurate atomic structure from three independent directions, e.g. in [0001]Mg, [ 110]Mg and [01 0]Mg zone axes, the unit cell of γ″ is well established. The γ″ phase has a hexagonal structure, and its lattice parameters are a = 0.55 nm and c = 0.42 nm. The orientation relationship between γ″ phase and Mg matrix is (0001)γ″//(0001)Mg and < 110>γ″//< 010>Mg.
3 February 2023 in Journal of Alloys and Compounds