Shenzhen, the first special economic zone of China, has witnessed earth-shaking changes since the late 1980s. In the past 35 years, about 80 km² of land has been reclaimed from the sea in Shenzhen. In order to investigate coastal vertical land motions associated with land reclamation, we proposed an elaborated Point Target (PT) based Small Baseline Subset InSAR (SBAS-InSAR) strategy to process an ENVISAT ASAR ascending and descending orbits dataset both acquired from 2007 to 2010. This new strategy can not only select high density PTs but also generate a reliable InSAR measurement with full spatial resolution. The inter-comparison between InSAR-derived deformation velocities from different orbits shows a good self-consistency of the results extracted by the elaborated PT-based SBAS-InSAR strategy. The InSAR measurements show that the reclaimed land is undergoing remarkable coastal subsidence (up to 25 mm/year), especially at the Shenzhen Airport, Bao’an Center, Qianhai Bay and Shenzhen Bay. By analyzing the results together with land reclamation evolution, we conclude that the ground deformation is expected to continue in the near future, which will amplify the regional sea level rise.

The Generic Atmospheric Correction Online Service (GACOS) products for interferometric synthetic aperture radar (InSAR) are widely used near-real-time and global-coverage atmospheric delay products which provide a new approach for the atmospheric correction of repeat-pass InSAR. However, it has not been determined whether these products can improve the accuracy of InSAR deformation monitoring. In this paper, GACOS products were used to correct atmospheric errors in short baseline subset (SBAS)-InSAR. Southern California in the U.S. was selected as the research area, and the effect of GACOS-based SBAS-InSAR was analyzed by comparing with classical SBAS-InSAR results and external global positioning system (GPS) data. The results showed that the accuracy of deformation monitoring was improved in the whole study area after GACOS correction, and the mean square error decreased from 0.34 cm/a to 0.31 cm/a. The improvement of the mid-altitude (15–140 m) point was the most obvious after GACOS correction, and the accuracy was increased by about 23%. The accuracy for low- and high-altitude areas was roughly equal and there was no significant improvement. Additionally, GACOS correction may increase the error for some points, which may be related to the low accuracy of GACOS turbulence data.

With the development of high-resolution Synthetic Aperture Radar (SAR) systems, researchers are increasingly paying attention to the application of SAR offset tracking methods in ground deformation estimation. The traditional normalized cross correlation (NCC) tracking method is based on regular matching windows. For areas with different moving characteristics, especially the landslide boundary areas, the NCC method will produce incorrect results. This is because in landslide boundary areas, the pixels of the regular matching window include two or more types of moving characteristics: some pixels with large displacement, and others with small or no displacement. These two kinds of pixels are uncorrelated, which result in inaccurate estimations. This paper proposes a new offset tracking method with SAR images based on the adaptive matching window to improve the accuracy of landslide displacement estimation. The proposed method generates an adaptive matching window that only contains pixels with similar moving characteristics. Three SAR images acquired by the Jet Propulsion Laboratory’s Uninhabited Aerial Vehicle Synthetic Aperture Radar (UAVSAR) system are selected to estimate the surface deformation of the Slumgullion landslide located in the southwestern Colorado, USA. The results show that the proposed method has higher accuracy than the traditional NCC method, especially in landslide boundary areas. Furthermore, it can obtain more detailed displacement information in landslide boundary areas.

Landslide monitoring is important for geological disaster prevention, where Synthetic Aperture Radar (SAR) images have been widely used. Compared with the Interferometric SAR (InSAR) technique, intensity-based offset tracking methods (e.g., Normalized Cross-Correlation method) can overcome the limitation of InSAR’s maximum detectable displacement. The normalized cross-correlation (NCC) method, based on single-channel SAR images, estimates azimuth and range displacement by using statistical correlation between the matching windows of two SAR images. However, the matching windows—especially for the boundary area of landslide—always contain pixels with different moving characteristics, affecting the precision of displacement estimation. Based on the advantages of polarimetric scattering properties, this paper proposes a fully polarimetric SAR (PolSAR) offset tracking method for improvement of the precision of landslide displacement estimation. The proposed method uses the normalized inner product (NIP) of the two temporal PolSAR Pauli scattering vectors to evaluate their similarity, then retrieve the surface displacement of the Slumgullion landslide located in southwestern Colorado, USA. A pair of L-band fully polarimetric SAR images acquired by the Jet Propulsion Laboratory’s Uninhabited Aerial Vehicle Synthetic Aperture Radar (UAVSAR) system are selected for experiment. The results show that the Slumgullion landslide’s moving velocity during the monitoring time ranges between 1.6–10.9 mm/d, with an average velocity of 6.3 mm/d. Compared with the classical NCC method, results of the proposed method present better performance in the sub-pixel estimation. Furthermore, it performs better when estimating displacement in the area around the landslide boundaries.

Ground deformation contains important information that can be exploited to look into the dynamics of a geothermal system. In recent years, InSAR has manifested its strong power in the monitoring of ground deformation. In this paper, a multi-temporal InSAR algorithm, WLS InSAR, is employed to monitor and characterize the Yangbajing geothermal field in Tibet, China, using 51 ENVISAT/ASAR images acquired from two overlapping descending tracks. The results reveal that the WLS InSAR algorithm can suppress the adverse effects of seasonal oscillations, associated with the freezing-thawing cycle of the permafrost in the Qinghai-Tibet Plateau. Deformations of up to 2 cm/yr resulting from the exploitation of the geothermal resource have been detected in the southern part of the Yangbajing field between 2006 and 2010. A source model inversion of the subsurface geothermal fluids was carried out based on the elastic half-space theory using the accumulated deformations. It was found that most geothermal fluid loss has occurred in the southern part of the shallow reservoir as the pore space beneath the northern part of field was recharged by the ascending flow from the deep layers of the reservoir through well-developed faults in the region.

In this study, we mapped the co-seismic deformation of the 2015 Mw 8.3 Illapel, Chile earthquake with multiple Sentinel-1A TOPS data frames from both ascending and descending geometries. To meet the requirement of very high co-registration precision, an improved spectral diversity method was proposed to correct the co-registration slope error in the azimuth direction induced by multiple Sentinel-1A TOPS data frames. All phase jumps that appear in the conventional processing method have been corrected after applying the proposed method. The 2D deformation fields in the east-west and vertical directions are also resolved by combing D-InSAR and Offset Tracking measurements. The results reveal that the east-west component dominated the 2D displacement, where up to 2 m displacement towards the west was measured in the coastal area. Vertical deformations ranging between −0.25 and 0.25 m were found. The 2D displacements imply the collision of the Nazca plate squeezed the coast, which shows good accordance with the geological background of the region.