The guided mode resonance (GMR) effect is widely used in biosensing due to its advantages of narrow linewidth and high efficiency. However, the optimization of a figure of merit (FOM) has not been considered for most GMR sensors. Aimed at obtaining a higher FOM of GMR sensors, we proposed an effective design method for the optimization of FOM. Combining the analytical model and numerical simulations, the FOM of “grating–waveguide” GMR sensors for the wavelength and angular shift detection schemes were investigated systematically. In contrast with previously reported values, higher FOM values were obtained using this method. For the “waveguide–grating” GMR sensors, a linear relationship between the grating period and groove depth was obtained, which leads to excellent FOM values for both the angular and wavelength resonance. Such higher performance GMR sensors will pave the way to lower detection limits in biosensing.

Whispering-gallery-mode (WGM) microbubble resonators are ideal optical sensors due to their high quality factor, small mode volume, high optical energy density, and geometry/design/structure (i.e., hollow microfluidic channels). When used in combination with microfluidic technologies, WGM microbubble resonators can be applied in chemical and biological sensing due to strong light–matter interactions. The detection of ultra-low concentrations over a large dynamic range is possible due to their high sensitivity, which has significance for environmental monitoring and applications in life-science. Furthermore, WGM microbubble resonators have also been widely used for physical sensing, such as to detect changes in temperature, stress, pressure, flow rate, magnetic field and ultrasound. In this article, we systematically review and summarize the sensing mechanisms, fabrication and packing methods, and various applications of optofluidic WGM microbubble resonators. The challenges of rapid production and practical applications of WGM microbubble resonators are also discussed.

We present a systematic investigation on the enhancement of the quality (Q) factors for guided-mode resonance (GMR) sensors with shallow subwavelength grating structures. By introducing the coupled-mode model, a theoretical high-Q factor can be achieved by choosing the proper geometric structure. Based on this method, a GMR sensor with a Q factor up to 8000, which is an order of magnitude larger than those of typical GMR sensors with Q factors within 100 ∼ 300, was demonstrated experimentally. Besides, the approached GMR sensor achieved a bulk sensitivity of 135 nm RIU ⁻¹ with a high signal to noise ratio, which supports a detection limit of 1 ng ml ⁻¹ for bovine serum albumin detection. This high performance GMR sensor paves the way towards high-throughput industrial mass production, and shows great potential for other applications, such as optical filters, spectrometer, and bio-imaging.

Asymmetric metasurfaces supporting quasi‐bound states in the continuum (BICs) with high Q‐factors and strong light–matter interaction properties are attractive platforms for label‐free biosensing applications. Recently, various meta‐atom geometries have been exploited to support sharp high‐Q quasi‐BIC resonance. However, which meta‐atom design may be a better practical choice remains unclear. Here, we compared several established meta‐atom designs to address this issue by conducting an extensive theoretical discussion on sensing capability and fabrication difficulty. We theoretically revealed that the tetramer meta‐atom geometry produces a higher surface sensitivity and exhibits a larger size‐to‐wavelength ratio than other meta‐atom schemes. Furthermore, we found that metasurfaces with a higher depth considerably enhance surface sensitivity. The performance of two asymmetric tetramer metasurfaces (ATMs) with different heights was demonstrated experimentally. Both shallow and thick ATM structures exhibit sharp high Q‐factor resonances with polarization‐insensitive features. Notably, the surface sensitivity is 1.62 times for thick ATM compared to that for shallow ones. The combination of properties opens new opportunities for developing biosensing or chemical‐sensing applications with high performance.

We propose an effective method for biomolecular detection based on an external referencing optofluidic microbubble resonator system (EROMBRS), which possesses good long-term stability and low noise. In this study, EROMBRSs were used for nonspecific detection of bovine serum albumin (BSA) molecules and specific detection of D-biotin molecules. Ultra-low practical detection limits of 1 fg/mL for nonspecific and specific biomolecular detection were achieved.