We propose and design a kind of heterogeneous rod-assisted and trench-assisted multi-core fiber (Hetero-RA-TA-MCF) with 32 cores arranged in square-lattice structure (SLS), and then we introduce the design method for Hetero-RA-TA-MCF. Simulation results show that the Hetero-RA-TA-32-Core-Fiber achieves average effective area (Aeff) of about 74 μm2, low crosstalk (XT) of about −31 dB/100km, threshold value of bending radius (Rpk) of 7.0 cm, relative core multiplicity factor (RCMF) of 8.74, and cable cutoff wavelength (λcc) of less than 1.53 μm.
We propose a bend-insensitive grapefruit-type holey ring-core fiber to support orbital angular momentum (OAM) modes. The large air domain in the cladding results in a large refractive index contrast between the ring-core and the cladding, which makes this fiber bend-insensitive and makes the vector eigenmodes well separated. Therefore, the proposed fiber can be adopted for the OAM mode division multiplexing transmission without the use of any multiple-input multiple-output digital signal processing (MIMO-DSP). It is also proved that the thickness of the outer silica layer around the ring-core plays an important role in confining the light. If the OAM modes in the ring-core and the cladding modes in the outer silica layer are not phase-matched, the OAM modes in the ring-core will not be coupled into the outer layer of silica and can be well confined. We fabricate such fiber in two steps by using the “stack-and-draw” method. Two kinds of fibers with different thicknesses of the outer silica layer are fabricated under different pressures and temperatures. The testing results of the fabricated fiber demonstrate the mode purity and illustrate that the loss of the OAM $+1,1$ and OAM $+2,1$ modes are 0.095 dB/m and 0.25 dB/m, respectively.
19 September 2023 in Journal of Lightwave Technology
We propose a center-raised ring-core fiber (RCF), which can support 5-mode-group-multiplexed multiple-input and multiple-output free (MIMO-free) transmission. The center region in the index profile of the ring core is lifted from silica to enlarge the separation of lower-order mode groups (MGs) so that the RCF supports more weakly-coupled MGs. Moreover, the 5-MG RCF was fabricated, and the loss of each mode can maintain about 0.3 dB/km. The minimum effective index separation between the adjacent radial first-order MGs is 1.35 $\times\; 10^{-3}$ . In addition, we also adopted the swept-wavelength interferometry (SWI) technique to evaluate the coupling coefficients between the radial first-order MGs in the RCF, which are all less than −30 dB/km. Furthermore, it is demonstrated that 5 MGs modulated by 32-Gbaud QPSK signals are multiplexed and transmitted in a 10-km RCF MIMO-free transmission system. To the best of our knowledge, it is the largest number of the multiplexed radial first-order MGs of the RCF at present. At the same time, we also verified the wavelength division multiplexing (WDM) performance of the fiber in the C-band. In the future, in order to further increase the transmission capacity of this fiber, 4 × 4 MIMO and dense WDM in C+L bands can be utilized. Therefore, we believe that this fiber can increase the number of weakly-coupled MGs to increase the single-fiber transmission capacity of mode division multiplexing (MDM).
We design and fabricate a dual-step-index ring-core fiber (RCF) for orbital angular momentum (OAM) mode transmission. It has been proven that the proposed novel, to the best of our knowledge, dual-step-index ring-core structure can suppress the spin–orbit coupling and cut off the radial higher-order modes when the mode number becomes very large. In experiments, we demonstrate that the fabricated fiber can support OAM8,1 with the interferometric method, where four higher-order mode groups are weakly-coupled. We also measure the loss of each mode according to the cut-back method and the loss can achieve <0.3 dB/km for the OAM modes with an order from |l| = 1 to |l| = 5. The exploration of this novel optical fiber structure may provide ideas and knowledge for the improvement of the optical fiber communication capacity.
Recently, orbital angular momentum (OAM) multiplexing has attracted much attention for providing an exponential growth in optical fiber capacity. As an irreplaceable component to promote long-haul OAM mode fiber transmission system, the on-line OAM mode-multiplexed fiber amplifier need to be developed. In this paper, we propose a Gaussian-like erbium doping distribution design method for ring-core erbium doped fiber (RC-EDF) to optimize the differential modal gain (DMG), which can reduce the fabrication complexity of the fiber preform. With a good match with original design, the fabricated RC-EDF was characterized by all the supporting four OAM modes ( $\vert l \vert$ = 1, 2, 3, 4) multiplexed amplification, which achieves an ultra-low DMG less than 0.3 dB at 1550 nm. The gain is above 15 dB and DMG is less than 1.2 dB for four OAM modes across the C-band under a 500 mW pump power. As a proof for transmission, 32 channels (8 wavelengths × 4 OAM modes) carrying 32-Gbaud quadrature phase-shift keying (QPSK) OAM modes multiplexed-WDM transmission over the OAM-EDFA is demonstrated. The proposed OAM-EDFA with the average OSNR penalties of 0.34 dB may promote the practical implementation for the long-haul OAM modes fiber transmission system.
Vector modes (VMs) with spatially nonhomogeneous polarization patterns, combining polarization and spatial-mode degrees of freedom together, are regarded as the eigenmodes of optical fiber. Such eigenmodes have potential to be used to implement the high capacity spatial division multiplexing (SDM)/mode division multiplexing (MDM) based optical fiber communication systems. Here, we respectively demonstrate 2 VMs of the same order (l = +2, EH11o and EH11e modes) and 2 VMs of different orders (l = 0, HE11o mode and l = +2, EH11e mode) multiplexing transmissions over 5-km few-mode fiber (FMF). The mode crosstalk after FMF transmission has been minimized to prepare high capacity signal transmission without multiple-input-multiple-output (MIMO) digital signal processing (DSP). To increase the transmission capacity and decrease the system cost, the Kramers-Kronig (KK) receiver has been employed and the single-wavelength two sets of eigenmodes multiplexed 360 Gbit/s and 400 Gbit/s signal transmissions over 5-km FMF link are realized, respectively. Then, to further burst the transmission capacity, 2 vector-mode-division-multiplexing channels (HE11o and EH11e modes) in combination of 5 wavelength-division-multiplexing (WDM) channels with a total of 10 parallel channels have been demonstrated. A total data rate of 1.12 Tbit/s with 28 GBaud 16-state quadrature amplitude modulation (QAM) signal has been realized over the 5-km FMF. In all data-carrying experimental demonstrations, the bit-error rate (BER) performance of each VM channel is below the 7% hard decision forward error correction threshold (FEC) at BER of 3.8 × 10 -3 . The experimental results highlight that the VMDM-based optical transmission technology could find enormous potential in huge-capacity short-reach optical interconnects.