This work focuses on forced combustion with regards to the relationship between vent mixer models and several injection locations in unheated supersonic flow. A plasma jet torch was used to ignite the hydrogen-air mixture in a laboratory-scaled combustor duct. The flow field of the combustion was visualized with pressure and gas-sampling measurements. The vent mixers indicate good dispersion characteristics of the mixture for both parallel and normal 1 injections. However, forced combustion is dominantly governed by the injection rate toward the plasma jet (hot source) because the combustible region is restricted under the cold main flow. For this reason, the parallel injection, which provides the hydrogen-air mixture directly toward the plasma jet, shows good combustion performance. The normal 1 injection interacted with the vent mixers and shows slightly good combustion performance. Lastly, the normal 2 injection is little affected by the vent mixers and has poor combustion performance.
1 August 2019 in Journal of the Korean Society of Propulsion Engineers
In this study we perform a computational numerical analysis to examine the flow characteristics of a system composed of a rocket engine, supersonic diffuser, and ejector system. When the nozzle expansion ratio of a rocket engine increases, it is necessary to maintain high-vacuum conditions during ground hot testing, which requires a supersonic diffuser and ejector system. The integrated model, consisting of multiple systems and a single-ejector system model, exhibits a difference in the initial volume to be evacuated. Although some differences are observed during the initial vacuum transition process, both models maintain the same final vacuum pressure (4 kPa). During the initial vacuum process, if the injection pressure of the ejector decreases below the design pressure, vacuum degradation occurs because of momentum deficiency, followed by pressure perturbations as the vacuum process resumes. Once the rocket engine ignites and flow is supplied to the suction region, two flow regions exist around the ejector nozzle exit. As these flows mix and move downstream, flow separation occurs in the expansion region. When the injection pressure of the ejector falls below the design pressure, the flow separation region moves forward, and this shift helps maintain the designed vacuum suction conditions.