Solar-driven water desalination technologies are rapidly developing with various links to other renewable sources. However, the efficiency of such systems severely depends on the design parameters. The present study focused on using graphene oxide (GO) with the Φ = 0.2, 0.4 and 0.6 wt.% dispersed in paraffin, as phase-change materials (PCMs), to improve the productivity of a solar still for desalination applications. The outcomes showed that by adding more graphene oxide to paraffin, the melting temperature got reduced. Solar still with GO/paraffin showed 25% productivity improvement in comparison with the solar still with only PCM. The obtained Nusselt number during the melting time also represented that free convection heat transfer into the melted region of the solar still has been enhanced by adding dispersed GO to the PCM, compared to the base paraffin. Also, increasing the hot wall temperature augments the Nusselt number. Finally, an empirical equation was derived to correlate the average Nusselt number as a function of Rayleigh number (Ra), the Stefan number (Ste), the subcooling factor (Sb), and the Fourier number (Fo). The obtained correlation depicted that Nusselt number enhancement has a reverse relation with Fourier number.
This study examined the heat transfer coefficient, friction loss, pressure drop and pumping power needed for the use of nanofluid coolants made of a mixture of suspension of graphene nanoplatelets–silver in water in a rectangular duct. A series of calculations were performed for the coolant volume flow rate in the range of 5000 ≤ Re ≤ 15,000 under a fully developed turbulent flow regime and different nanosheet concentrations up to 0.1 weight percent. The thermo-physical properties of the nanofluids were extracted from the recent experimental work of Yarmand et al. (Graphene nanoplatelets-silver hybrid nanofluids for enhanced heat transfer. Energy Convers. Manag. 2015, 100, 419–428). The presented results indicated that the heat transfer characteristics of the nanofluid coolants improved with the increase in nanosheet concentration as well as the increase in the coolant Reynolds number. However, there was a penalty in the duct pressure drop and an increase in the required pumping power. In summary, the closed conduit heat transfer performance can be improved with the use of appropriate nanofluids based on graphene nanoplatelets–silver/water as a working fluid.
In this study, the heat transfer characteristics within the heat exchanger using water-based GO nanofluids were comprehensively assessed. An apparatus was constructed by scaling down an industrial heat exchanger. The nanofluid's thermal conductivity, specific heat capacity, viscosity, density, Prandtl number, and Nusselt number were examined at varying temperatures and GO nanoparticle concentrations. The results revealed that the thermal conductivity of the nanofluid increased with both temperature and nanoparticle concentration, reaching a peak value of 0.380 W m-1 K-1 at 85 °C and 0.1 wt %, leading to enhanced heat transfer rates through conduction and convection mechanisms. The specific heat capacity increased with temperature but decreased with higher GO nanoparticle contents with a maximum value of 3403.821 J kg-1 K-1 recorded at 40 °C and 0.01 wt %. The viscosity of the nanofluid increased with higher concentrations of GO nanoparticles, and the minimum value of 0.83 mPa s was observed at 85 °C and 0.01 wt %. The Prandtl number decreased with the temperature but increased with increasing GO nanoparticle concentration, suggesting a transition from convective to conductive heat transfer. A newly derived correlation equation for the Nusselt number, Nu = 0.0059(1 + 7.62ϕ0.6886)Pe0.001Re0.9238Pr0.4, allows predicting heat transfer enhancement in nanofluids. The findings emphasize the potential of nanofluids for improving heat exchanger performance and offer valuable insights into optimizing nanofluid applications in thermal systems.
26 March 2021 in Journal of Thermal Analysis and Calorimetry