Caitlin Glover

Dr. Caitlin Glover


Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 November 2018 in Water Research
Verified
Journal Article
Open access
CGCaitlin Glover
Caitlin Glover
OQOscar Quiñones
Oscar Quiñones
EDEric R.V. Dickenson
Eric R.V. Dickenson
Perfluoroalkyl and polyfluoroalkyl substances (PFASs) are a group of persistent contaminants that have been identified throughout the aquatic environment. In this study, ten targeted perfluoroalkyl acids (PFAAs), three targeted PFAA precursors, and non-targeted PFAA precursors were monitored in four full- and pilot-scale potable reuse plants at each stage of advanced treatment. Non-targeted PFAA precursors were quantified by applying a total oxidizable precursor assay in which PFAA precursors are oxidized by hydroxyl radicals to targeted PFAAs. Two of the potable reuse systems had membrane-based treatments with reverse osmosis and UV-advanced oxidation (RO-UV/AOP) and two used ozone, biological activated carbon filtration and granular activated carbon adsorption (O3-BAC-GAC). The total targeted PFAAs in the four tertiary effluents, the influent sources for the potable reuse systems, ranged from 52 to 227 ng/L with non-targeted PFAA precursors accounting for 30-67% of total PFASs on a molar basis. The RO-UV/AOP treatment trains reduced PFAAs and PFAA precursors to below their method reporting limits through the barrier provided by RO. The O3-BAC-GAC based treatment trains reduced, but did not completely remove PFAAs or PFAA precursors and the PFASs present in the product water were primarily shorter-chain PFAAs, some of which lack human health guidance values for drinking water. The relative fraction of targeted shorter-chain PFAAs increased after each treatment step indicating that there was preferential removal of the PFAA precursors and longer-chain PFAAs. This study provides new insight on the concentrations and treatment of PFAA precursors through potable reuse treatment systems.

1 October 2021 in Water Research
Verified
Journal Article
Closed access
CGCaitlin Glover
Caitlin Glover
YLYang Liu
Yang Liu
JLJinxia Liu
Jinxia Liu

1 January 2019 in Water Research
Verified
Journal Article
Open access
CGCaitlin Glover
Caitlin Glover
EVEdgard M. Verdugo
Edgard M. Verdugo
RTRebecca A. Trenholm
Rebecca A. Trenholm
EDEric R.V. Dickenson
Eric R.V. Dickenson
As potable reuse guidelines and regulations continue to develop, the presence of N-nitrosamines is a primary concern because of their associated health concerns. In this study, bench-, pilot-, and full-scale tests were conducted to focus on the occurrence and treatment of N-nitrosomorpholine (NMOR) in United States (U.S.) potable reuse systems. Out of twelve U.S. wastewater effluents collected, ambient NMOR was detected in eleven (average = 20 ± 18 ng/L); in contrast, only two of the thirteen surface water and stormwater samples had NMOR. Across all of these samples maximum formation potential by chloramination produced an average increase of 3.6 ± 1.8 ng/L. This result underscores the need to understand the sources of NMOR as it is not likely a disinfection byproduct and it is not known to be commercially produced within the U.S. At the pilot-scale, three potable reuse systems were evaluated for ambient NMOR with oxidation (i.e., chlorination and ozonation), biofiltration, and granular activated carbon (GAC). Both pre-oxidation and biofiltration were ineffective at mitigating NMOR during long-term pilot plant operation (at least eight-months). GAC adsorbers were the only pilot-scale treatment to remove NMOR; however, complete breakthrough occurred rapidly from <2000 to 10,000 bed volumes. For comparison, a full-scale reverse osmosis (RO) potable reuse system was monitored for a year and confirmed that RO effectively removes NMOR. Systematic bench-scale UV-advanced oxidation experiments were undertaken to assess the mitigation potential for NMOR. At a fluence dose of 325 ± 10 mJ/cm2, UV alone degraded 90% of the NMOR present. The addition of 5 mg/L hydrogen peroxide did not significantly decrease the UV dose required for one-log removal. These data illustrate that efficient NMOR removal from potable reuse systems is limited to RO or UV treatment.

13 April 2020 in Water
Verified
Journal Article
Open access
PDF file
Arash ZamyadiArash Zamyadi
Arash Zamyadi
KGKatherine Greenstein
Katherine Greenstein
CGCaitlin Glover
Caitlin Glover
CACraig Adams
Craig Adams
ERErik Rosenfeldt
Erik Rosenfeldt
EWEric Wert
Eric Wert
Algicides, like hydrogen peroxide and copper sulfate, are commonly applied to recreational waters and drinking water sources to mitigate cyanobacterial blooms. In this work, the effects of hydrogen peroxide and copper sulfate were evaluated in two natural bloom samples (collected from Canadian and American waterbodies) and one lab-cultured Microcystis aeruginosa suspended in Colorado River water. Five algicide to dissolved organic carbon (DOC) dose ratios were evaluated during an initial exposure period of 24 h. One dose ratio (0.4 H2O2:DOC or 0.25 CuSO4:DOC) was then evaluated during stagnation after quenching (hydrogen peroxide) or extended exposure (copper sulfate) for up to 96 or 168 h. During the initial hydrogen peroxide exposure, the CA bloom had no release of intracellular microcystins (MCs) and the USA bloom only released MC at 4 H2O2:DOC. The reverse occurred with copper sulfate, where the CA bloom released MCs at 0.6 CuSO4:DOC but the USA bloom had no detectable extracellular MCs. Extracellular MC was released from the lab-cultured Microcystis at the lowest hydrogen peroxide and copper sulfate doses. In the hydrogen peroxide stagnation experiment, intracellular MC decreased in the USA bloom after 168 h despite the low dose applied. Similarly, the extended copper sulfate exposure led to intracellular MC decreases in both bloom samples after 168 h, despite showing no impact during the initial 24 h monitoring period. The lab-cultured Microcystis was again less resistant to both algicides, with releases observed after less than 2 h of stagnation or exposure. The damage to cells as measured by pigments during these experiments did not match the MC data, indicating that blooms with depressed pigment levels can still be a risk to nearby drinking water sources or recreational activities. These results provide insight on the timeline (up to one week) required for monitoring the potential release of MCs after algicide application.

20 May 2020 in Toxins
Verified
Journal Article
Open access
PDF file
KGKatherine Greenstein
Katherine Greenstein
Arash ZamyadiArash Zamyadi
Arash Zamyadi
CGCaitlin Glover
Caitlin Glover
CACraig Adams
Craig Adams
ERErik Rosenfeldt
Erik Rosenfeldt
EWEric Wert
Eric Wert
Oxidation processes can provide an effective barrier to eliminate cyanotoxins by damaging cyanobacteria cell membranes, releasing intracellular cyanotoxins, and subsequently oxidizing these toxins (now in extracellular form) based on published reaction kinetics. In this work, cyanobacteria cells from two natural blooms (from the United States and Canada) and a laboratory-cultured Microcystis aeruginosa strain were treated with chlorine, monochloramine, chlorine dioxide, ozone, and potassium permanganate. The release of microcystin was measured immediately after oxidation (t ≤ 20 min), and following oxidant residual quenching (stagnation times = 96 or 168 h). Oxidant exposures (CT) were determined resulting in complete release of intracellular microcystin following chlorine (21 mg-min/L), chloramine (72 mg-min/L), chlorine dioxide (58 mg-min/L), ozone (4.1 mg-min/L), and permanganate (391 mg-min/L). Required oxidant exposures using indigenous cells were greater than lab-cultured Microcystis. Following partial oxidation of cells (oxidant exposures ≤ CT values cited above), additional intracellular microcystin and dissolved organic carbon (DOC) were released while the samples remained stagnant in the absence of an oxidant (>96 h after quenching). The delayed release of microcystin from partially oxidized cells has implications for drinking water treatment as these cells may be retained on a filter surface or in solids and continue to slowly release cyanotoxins and other metabolites into the finished water.

17 May 2019 in Toxins
Verified
Journal Article
Open access
PDF file
SMSaber Moradinejad
Saber Moradinejad
CGCaitlin Glover
Caitlin Glover
JMJacinthe Mailly
Jacinthe Mailly
TZTahere Zadfathollah
Tahere Zadfathollah
SPSigrid Peldszus
Sigrid Peldszus
Arash ZamyadiArash Zamyadi
Arash Zamyadi
Drinking water treatment plants throughout the world are increasingly facing the presence of toxic cyanobacteria in their source waters. During treatment, the oxidation of cyanobacteria changes cell morphology and can potentially lyse cells, releasing intracellular metabolites. In this study, a combination of techniques was applied to better understand the effect of oxidation with chlorine, ozone, potassium permanganate, and hydrogen peroxide on two cell cultures (Microcystis, Dolichospermum) in Lake Champlain water. The discrepancy observed between flow cytometry cell viability and cell count numbers was more pronounced for hydrogen peroxide and potassium permanganate than ozone and chlorine. Liquid chromatography with organic carbon and nitrogen detection was applied to monitor the changes in dissolved organic matter fractions following oxidation. Increases in the biopolymer fraction after oxidation with chlorine and ozone were attributed to the release of intracellular algal organic matter and/or fragmentation of the cell membrane. A novel technique, Enhanced Darkfield Microscopy with Hyperspectral Imaging, was applied to chlorinated and ozonated samples. Significant changes in the peak maxima and number of peaks were observed for the cell walls post-oxidation, but this effect was muted for the cell-bound material, which remained relatively unaltered.