Ebola virus disease has reemerged as a major public health crisis in Africa, with isolated cases also observed globally, during the current outbreak. To estimate the basic reproductive ratio R0, which is a measure of the severity of the outbreak, we developed a SEIR (susceptible-exposed-infected-recovered) type deterministic model, and used data from the Centers for Disease Control and Prevention (CDC), for the Ebola outbreak in Liberia and Sierra Leone. Two different data sets are available: one with raw reported data and one with corrected data (as the CDC suspects under-reporting). Using a deterministic ordinary differential equation transmission model for Ebola epidemic, the basic reproductive ratio R0 for Liberia resulted to be 1.757 and 1.9 for corrected and uncorrected case data, respectively. For Sierra Leone, R0 resulted to be 1.492 and 1.362 for corrected and uncorrected case data, respectively. In each of the two cases we considered, the estimate for the basic reproductive ratio was initially greater than unity leading to an epidemic outbreak. We obtained robust estimates for the value of R0 associated with the 2014 Ebola outbreak, and showed that there is close agreement between our estimates of R0. Analysis of our model also showed that effective isolation is required, with the contact rate in isolation less than one quarter of that for the infected non-isolated population, and that the fraction of high-risk individuals must be brought to less than 10% of the overall susceptible population, in order to bring the value of R0 to less than 1, and hence control the outbreak.
We formulate a deterministic epidemic model for the spread of Corona Virus Disease (COVID-19). We have included asymptomatic, quarantine and isolation compartments in the model, as studies have stressed upon the importance of these population groups on the transmission of the disease. We calculate the basic reproduction number and show that for the disease dies out and for the disease is endemic. Using sensitivity analysis we establish that is most sensitive to the rate of quarantine and isolation and that a high level of quarantine needs to be maintained as well as isolation to control the disease. Based on this we devise optimal quarantine and isolation strategies, noting that high levels need to be maintained during the early stages of the outbreak. Using data from the Wuhan outbreak, which has nearly run its course we estimate that which while in agreement with other estimates in the literature is on the lower side.
The 2014 Ebola epidemic is the largest in history, affecting multiple countries in West Africa. Some isolated cases were also observed in other regions of the world. In this paper, we introduce a deterministic SEIR type model with additional hospitalization, quarantine and vaccination components in order to understand the disease dynamics. Optimal control strategies, both in the case of hospitalization (with and without quarantine) and vaccination are used to predict the possible future outcome in terms of resource utilization for disease control and the effectiveness of vaccination on sick populations. Further, with the help of uncertainty and sensitivity analysis we also have identified the most sensitive parameters which effectively contribute to change the disease dynamics. We have performed mathematical analysis with numerical simulations and optimal control strategies on Ebola virus models. We used dynamical system tools with numerical simulations and optimal control strategies on our Ebola virus models. The original model, which allowed transmission of Ebola virus via human contact, was extended to include imperfect vaccination and quarantine. After the qualitative analysis of all three forms of Ebola model, numerical techniques, using MATLAB as a platform, were formulated and analyzed in detail. Our simulation results support the claims made in the qualitative section. Our model incorporates an important component of individuals with high risk level with exposure to disease, such as front line health care workers, family members of EVD patients and Individuals involved in burial of deceased EVD patients, rather than the general population in the affected areas. Our analysis suggests that in order for R 0 (i.e., the basic reproduction number) to be less than one, which is the basic requirement for the disease elimination, the transmission rate of isolated individuals should be less than one-fourth of that for non-isolated ones. Our analysis also predicts, we need high levels of medication and hospitalization at the beginning of an epidemic. Further, optimal control analysis of the model suggests the control strategies that may be adopted by public health authorities in order to reduce the impact of epidemics like Ebola.
Dengue, an infectious tropical disease, has recently emerged as one of the most important mosquito-borne viral diseases in the world. We perform a retrospective analysis of the 2011 dengue fever epidemic in Pakistan in order to assess the transmissibility of the disease. We obtain estimates of the basic reproduction number R 0 from epidemic data using different methodologies applied to different epidemic models in order to evaluate the robustness of our estimate.
19 March 2025 in Journal of Low Frequency Noise, Vibration and Active Control
This investigation employs the “Tantawy Technique,” a novel, highly accurate, and fast technique, to solve and analyze the fourth-order time-fractional Cahn–Hilliard (TFCH) models. We also implement the variational iteration transform method (VITM) and the homotopy perturbation transform method (HPTM) within the Yang transform framework to analyze the fourth-order TFCH models. These iterative procedures enable the acquisition of solutions in a convergent series. We focus on two nonlinear issues in the current investigation to demonstrate the validity and accuracy of the suggested approaches. We check the derived approximations against the exact solutions for the integer cases and then find their absolute error to ensure their accuracy and stability. The present approaches show how different fractional orders affect the profile of the derived approximations. The presented issues demonstrate the precision and effectiveness of the suggested techniques in tackling strong nonlinear fractional differential equations. Implementing the suggested methodologies indicates that as the value of the fractional parameter transitions from fractional to integer order, the result approaches the exact solution for the integer case. These methods also make it straightforward to use fractal calculus in real life. The numerical analysis results demonstrate that the proposed iterative techniques are viable and user-friendly tools with high computational efficiency when used in various physical models in science and engineering.
Mathematical models can be very useful in determining efficient and successful antibiotic dosing regimens. In this study, we consider the problem of determining optimal antibiotic dosing when bacteria resistant to antibiotics are present in addition to susceptible bacteria. We consider two different models of resistance acquisition, both involve the horizontal transfer (HGT) of resistant genes from a resistant to a susceptible strain. Modeling studies on HGT and study of optimal antibiotic dosing protocols in the literature, have been mostly focused on transfer of resistant genes via conjugation, with few studies on HGT via transformation. We propose a deterministic ODE based model of resistance acquisition via transformation, followed by a model that takes into account resistance acquisition through conjugation. Using a numerical optimization algorithm to determine the ‘best’ antibiotic dosing strategy. To illustrate our optimization method, we first consider optimal dosing when all the bacteria are susceptible to the antibiotic. We then consider the case where resistant strains are present. We note that constant periodic dosing may not always succeed in eradicating the bacteria while an optimal dosing protocol is successful. We determine the optimal dosing strategy in two different scenarios: one where the total bacterial population is to be minimized, and the next where we want to minimize the bacterial population at the end of the dosing period. We observe that the optimal strategy in the first case involves high initial dosing with dose tapering as time goes on, while in the second case, the optimal dosing strategy is to increase the dosing at the beginning of the dose cycles followed by a possible dose tapering. As a follow up study we intend to look at models where ‘persistent’ bacteria may be present in additional to resistant and susceptible strain and determine the optimal dosing protocols in this case.