In this work, three typical morphologies of SERS substrates with the compositions of Au nanoparticles, short Au nanowires (NWs) with small Au nanoparticles filled in the nanogaps and long Au NWs intertwined into a self-supporting film, were fabricated by a versatile nanocluster fabrication technique. This physical fabrication technique is easy to implement and cost-effective, and the fabricated SERS substrates have a large-area, good homogeneity and long-term stability. More importantly, the SERS substrates prepared by this physical method will not incorporate reductants and surfactant chemicals, and thus can yield clean surfaces, which are suitable for analytes with a weak affinity to the substrate surface. In this study, the fabricated substrate with the highest enhancement factor (EF) successfully acquired the SERS spectrum of sodium cyclamate, a restricted food additive, with a good signal–noise-ratio. Finally, a set of piece-wise linear equations were produced according to the correlation between SERS intensity and sodium cyclamate concentration with a detection limit of 1.6 × 10−9 M.
Raman spectroscopy is a common identification and analysis technique used in research and manufacturing industries. This study investigates the use of Raman spectroscopy and deep learning techniques for identifying various nanofabrication chemicals. Four solvents and SU-8 developer were identified inside common chemical storage and distribution containers. The containers attenuated the spectra and contributed varying amounts of background fluorescence, making manual identification difficult. Two varieties of SU-8 photoresist were differentiated inside amber glass jars, and cured samples of three ratios of polydimethylsiloxane (PDMS) were differentiated using Raman microscopy. The neural network accurately identified the nanofabrication chemicals 100% of the time, without additional preprocessing. This investigation demonstrates the use of Raman spectroscopy and neural networks for the identification of nanofabrication chemicals and makes recommendations for use in other challenging identification applications.
Antibiotic-resistant bacteria have emerged as an imminent global threat. The lack of rapid and sensitive diagnostic techniques leaves health care providers with inadequate resources for guiding therapy and risks the lives of patients. The traditional plate culturing methods for identifying antibiotic-resistant bacteria is laborious and time-consuming. Bulk PCR (Polymerase Chain Reaction) and qPCR are limited by poor detection sensitivity, which is critical for the early-stage detection of bloodstream infections. In this study, we introduce a technique for detecting β-lactamase-producing bacteria at single-cell sensitivity based on a commercial β-lactamase sensor (Fluorocillin), droplet microfluidics, and a custom 3D particle counter. Bacteria-containing samples were encapsulated within picoliter-sized droplets at the single-cell level and cultured within water-in-oil droplets containing antibiotics and the Fluorocillin sensor. Then, fluorescent droplets were digitally quantified with the 3D particle counter, which is capable of analyzing milliliter-scale volumes of collected droplets within 10 min. The fluorescence signal from single-colony droplets was detectable in less than 5 h, and the 3D scanning was performed in less than 10 min, which was significantly faster than conventional culture-based methods. In this approach, the limit of detection achieved was about 10 bacterial cells per mL of sample, and the turnaround time from sample to result was less than 6 h. This study demonstrates a promising strategy for the detection of β-lactamase-producing bacteria using the recently developed IC 3D system.