6 July 2010 in Nanotechnology
Tuning of the localized surface plasmon resonance (LSPR) of nanoporous metals is at the heart of manipulating light within extremely small volumes for the implementation of optical devices at the nanoscale. In this work, nanoporous gold-alumina core-shell films with fixed gold skeletons and different thicknesses of alumina shells are fabricated using chemical corrosion and subsequent atomic layer deposition. Optical transmission of the nanoporous composite films can be tailored through LSPR excitations of the three-dimensional gold skeleton and the alterable alumina shells as the covering dielectric. A 92 nanometer red-shift of the LSPR band is attained via its dielectric medium dependence and the comparable decay length with pore size. The widely tunable optical transmission and significantly improved stability thus suggest incorporating nanoporous gold-alumina into promising nano-devices with reliable performance. Low temperature surface decoration (<100 degrees C) provides a universal route to tune the optical properties while retaining the spatial geometry of the metallic nanostructures.
1 October 2019 in Physica E: Low-dimensional Systems and Nanostructures
1 January 2012 in Journal of Materials Chemistry
Micron and sub-micron particles tend to be self-organized into well-defined arrays during conventional convective assembly, however this technique hardly works for the assembly of tiny nanoparticles smaller than 10 nm into monolayered arrays. The intrinsic difficulty is mainly related to the evaporation and convections occurring at a much larger volume than nanoparticle size. As a result, multilayered nanoparticle arrays are usually created. In this paper, we report that solvent evaporation and nanoparticle convection are artificially confined in nanoscale grooves near a pipette's periphery and the grooves can help assemble parallel strips because of the uni-directional translation of the pipette. The stacking layer of each strip is correlated with the grooves' diameter, thus the nanoparticle monolayer is fabricated in the tiny grooves. The narrowest strip width observed experimentally is geometrically limited by the effective diameter of the charged nanoparticles in gold colloid because nanoparticle convections from the inner chamber to the pipette's periphery will not occur within the grooves finer than the effective diameters.
1 May 2014 in RSC Advances
In this work, three typical morphologies of SERS substrates with the compositions of Au nanoparticles, short Au nanowires (NWs) with small Au nanoparticles filled in the nanogaps and long Au NWs intertwined into a self-supporting film, were fabricated by a versatile nanocluster fabrication technique. This physical fabrication technique is easy to implement and cost-effective, and the fabricated SERS substrates have a large-area, good homogeneity and long-term stability. More importantly, the SERS substrates prepared by this physical method will not incorporate reductants and surfactant chemicals, and thus can yield clean surfaces, which are suitable for analytes with a weak affinity to the substrate surface. In this study, the fabricated substrate with the highest enhancement factor (EF) successfully acquired the SERS spectrum of sodium cyclamate, a restricted food additive, with a good signal–noise-ratio. Finally, a set of piece-wise linear equations were produced according to the correlation between SERS intensity and sodium cyclamate concentration with a detection limit of 1.6 × 10−9 M.
22 December 2021 in INTERNATIONAL JOURNAL OF ELECTRONICS AND APPLIED RESEARCH