Tidal flats, where significant land‐ocean interactions take place, are often abstracted as a cross‐shore bed profile with sediment zonation from the lower sand flat to the upper mud flat. However, in addition to cross‐shore tidal currents, the impact of the alongshore components on cross‐shore sediment transport, morphological evolution, and sediment grain‐size change remains unclear. Here we investigated sand‐mud tidal flat morphodynamics in the absence of waves by combining approaches of field observations, numerical modeling, and analytical interpretations, based on the example of the tidal flat on the central Jiangsu coast, China. The results show that the morphodynamic processes are complicated by the interactions of cross‐shore and alongshore tidal currents, cross‐shore flat morphology, and sediment zonation. With amplified phase lags of the alongshore tidal level at the boundaries, alongshore currents become dominant over cross‐shore tidal currents on the lower flat, while the upper flat is always dominated by the cross‐shore currents. Therefore, bed profiles and mud content on the upper flat were independent of the alongshore tidal current magnitude, being convex‐up and consisting of mud. In contrast, the strong alongshore currents can erode mud on the lower flat and promote landward sand transport from the subtidal area to the lower flat, forming a sand flat. The maximum tidal bed shear stress is almost spatially uniform across the muddy area but pronouncedly elevated where the bed sediment coarsens on the lower flat. The contributions of the alongshore tidal currents and sand‐mud sorting processes should be appropriately addressed in similar coastal environments.

In environments of high suspended sediment concentration (SSC > 1 kg/m³), efficient measurements of SSC through accurate calibration relationships between turbidity and SSC are necessary for studies on marine sediment dynamics. Here, we investigated the performance of three types of optical instrument (OBS-3A, AQUAlogger 310TY, and RBRsolo³Tu with Seapoint sensor) in observations carried out at the middle of the Jiangsu coast, China. These instruments were calibrated in the lab using the water and suspended sediment samples collected from the observation site. It was found that both the calibration curves of OBS-3A and RBRsolo³Tu have an inflection point (at SSC of ca. 15 kg/m³ for OBS-3A and ca. 2 kg/m³ for RBRsolo³Tu), on either side of which turbidity increases (the left side) or decreases (the right side) with the increasing SSC. Only under SSCs smaller than the inflection point can OBS-3A and RBRsolo³Tu be applied to continuous SSC measurements at a fixed point. However, the turbidity output of AQUAlogger 310TY has always a positive correlation with SSC, which applies for SSC up to 40 kg/m³; thus, three fluid-mud events are quantified during this observation. AQUAlogger 310TY has important prospects for field applications in high-SSC environments.