Seismic fragility analysis for bridges is an essential issue for risk assessment of transportation networks exposed to seismic hazards. Considering multiple Performance Limit States (PLSs) and seismic demand parameters, the study proposes a multidimensional fragility evaluation methodology for engineering structures, and the objective of the paper is to show that the uncertainty and dependence between seismic demand parameters should be considered for fragility analysis. Thus, a new Probabilistic Seismic Demand Model (PSDM) following multivariate logarithmic normal distribution is addressed. Taking PLS correlation into consideration, multidimensional PLS formula is constructed to identify the structural failure domain. A RC bridge is studied to show the proposed theory. To consider bridge column plastic deformation and bearing nonlinear characteristic, nonlinear dynamic analyses are carried out. The bridge multidimensional fragility curves are derived and compared with fragility curves for an individual component. Results indicate that uncertainty and dependence of demand parameters can be properly dealt with by the multivariate PSDM. The multidimensional fragility is higher than fragility of any individual component, and the bridge as a system is more fragile. The ignorance of multiple components contribution to the system will generate an overestimation for the whole structural performance, which is adverse to engineering structural safety.

The bonding status between Carbon Fiber Reinforced Polymer (CFRP) and concrete is one of the key issues for the safety of CFPR-reinforced structures, thus it is of great importance to detect the debonding as early as possible. Instead of detecting the debonding which is artificially set at the very beginning, this paper investigates the feasibility of using low-cost piezoceramic sensors to detect and monitor the debonding of CFRP-reinforced concrete beams in situ. For existing debonding detection, a concrete beam reinforced with CFRP sheet was loaded through the three-point bending test till failure to induce debonding between CFRP sheet and the concrete substrate, and piezoceramic sensors were used to detect the existing debonding by analyzing the receiving ultrasonic waves. In addition, the debonding detection results were further compared with and verified by the vision-based strain testing results. For in-situ debonding monitoring, 10 piezoceramic sensors were used as an array to track the wave transmission changes during the loading process of a CFRP-reinforced concrete beam, and the debonding development process was successfully monitored. The test results show that the low-cost piezoceramic sensors are very effective to generate and receive ultrasonic waves, and are capable of detecting the existing debonding and monitoring of the in-situ debonding process as well.