CaCO3 precipitation is physical-chemical basis of biomineral formation of hard tissue (shells, skeletons) in marine calcifying organisms (=biomineralization). Processes controlling biomineralization are still not fully clarified, so the study of influence of pH on basic processes of CaCO3 precipitation should contribute to better understanding of biomineralization under climate change. This paper reports on the effect of initial pH (pH0) and type of stirring (mechanical and magnetical) on spontaneous precipitation and phase composition, size and morphology of spontaneously precipitated CaCO3 formed at the identical initial supersaturation, ionic strength and a(Ca2+)/a(CO32−) ratio. The initial pH varied in a range 8.50 ≤ pH0 ≤ 10.50 and included values relevant for mimicking the conditions related to biomineralization in marine organisms. In all systems two CaCO3 polymorphs were found: calcite and/or vaterite. The increase of pH0 favoured the formation of rhombohedral calcite no matter the type of stirring. This was exclusively influenced by the systems’ pH0 (other relevant initial parameters were identical). Furthermore, increase of pH0 caused change of vaterite morphology from cauliflower-like spheroids to regular spherulites. The mechanically stirred systems produced larger calcite and vaterite particles and higher content of calcite.
Gallic acid and its metal complexes are good antioxidants that could be used to increase the body's immune system against degenerative and viral diseases. Therefore, such complexes could be used as a good alternative to supplementary medicines and may have potential significance in clinical trials. Differential pulse voltammetry, UV/VIS spectroscopy, and potentiometry were used to analyse the complexation of gallic acid with calcium in this study. The metal : ligand ratio was determined using Job's continuous variation method and was found to be 2 : 1. The stability constant of calcium gallate was determined with potentiometric titration with a calcium electrode, which amounted to K° = 4.83 × 106 (log K° = 6.7). The combination of the results obtained in this study gives a deeper insight into the complexation of gallic acid with calcium and determines the stability constant of calcium gallate.
The constantly growing need for advanced bone regeneration materials has motivated the development of calcium phosphates (CaPs) composites with a different metal or metal-oxide nanomaterials and their economical and environmentally friendly production. Here, two procedures for the synthesis of CaPs composites with TiO2 nanoplates (TiNPl) and nanowires (TiNWs) were tested, with the immersion of TiO2 nanomaterials (TiNMs) in corrected simulated body fluid (c-SBF) and precipitation of CaP in the presence of TiNMs. The materials obtained were analyzed by powder X-ray diffraction, spectroscopic and microscopic techniques, Brunauer–Emmett–Teller surface area analysis, thermogravimetric analysis, dynamic and electrophoretic light scattering, and their hemocompatibility and ability to induce reactive oxygen species were evaluated. After 28 days of immersion in c-SBF, no significant CaP coating was formed on TiNMs. However, the composites with calcium-deficient apatite (CaDHA) were obtained after one hour in the spontaneous precipitation system. In the absence of TiNMs, CaDHA was also formed, indicating that control of the CaP phase formed can be accomplished by fine-tuning conditions in the precipitation system. Although the morphology and size of crystalline domains of CaDHA obtained on the different nanomaterials differed, no significant difference was detected in their local structure. Composites showed low reactive oxygen species (ROS) production and did not induce hemolysis. The results obtained indicate that precipitation is a suitable and fast method for the preparation of CaPs/TiNMs nanocomposites which shows great potential for biomedical applications.
Liposomes (lipid vesicles) are often considered to be a versatile tool for the synthesis of advanced materials, as they allow various control mechanisms to tune the materials’ properties. Among diverse materials, the synthesis of calcium phosphates (CaPs) and calcium carbonates (CaCO3) using liposomes has attracted particular attention in the development of novel (bio)materials and biomineralization research. However, the preparation of materials using liposomes has not yet been fully exploited. Most of the liposomes used have been anionic and/or zwitterionic, while data on the influence of cationic liposomes are limited. Therefore, the aim of this study was to investigate and compare the influence of differently charged liposomes on CaPs and CaCO3 formation. Zwitterionic 1,2-dimyristoyl-sn-glycero-3-phosphocholine (DMPC), negatively charged 1,2-dimyristoyl-sn-glycero-3-phospho-L-serine (DMPS), and positively charged 1,2-dioleoyl-sn-glycero-3-ethylphosphocholine (EPC) lipids were used to prepare the respective liposomes. The presence of liposomes during the spontaneous precipitation of CaPs and CaCO3 affected both the precipitation and transformation kinetics, as well as the morphology of the precipitates formed. The most prominent effect was noted for both materials in the presence of DMPS liposomes, as (nano) shell structures were formed in both cases. The obtained results indicate possible strategies to fine-tune the precipitation process of CaPs and CaCO3, which may be of interest for the production of novel materials.