Shaohong Li

Dr. Shaohong Li


Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 December 2015 in Materials Science and Technology
Verified
Journal Article
Closed access
SLShaohong Li
Shaohong Li
XWX. Wu
X. Wu
The microstructural evolution and structure–property correlation subjected to deep cryotreatment of tool steel were studied. The results show that the retained austenite continues to transform into martensite almost but not complete at low temperature. The topography of retained austenite exhibits as a nanoscale thin film with a thickness range of 20–60 nm between the martensite laths. The changes of internal friction peaks have been explained well by the coupling model, which indicates that deep cryotreatment is not only removing retained austenite but also promoting the interstitial carbon atoms segregated to nearby dislocations under the shrinking strain energy. In addition, more carbides precipitated from the matrix during tempering in cryotreated samples and were verified by analyses of transmission electron microscopy.

28 July 2022 in Metals
Verified
Journal Article
Open access
PDF file
HBHengyong Bu
Hengyong Bu
QLQin Li
Qin Li
SLShaohong Li
Shaohong Li
MLMengnie Victor Li
Mengnie Victor Li
Isothermal compression behaviors of 5CrNiMoV steel were studied at temperatures of 870, 800, 750, and 700 °C, with strain rates of 0.001, 0.005, 0.01, 0.05, and 0.1 s−1, the compression temperatures 870 and 800 °C are above Ac3, as well as 750 and 700 °C below Ac3 temperature. The Modified Johnson–Cook (MJC) model and the Strain–Compensated Arrhenius (SCA) model were employed to demonstrate the relationship between the flow stress and the compression parameters. The correlation coefficient (R) and average absolute relative error (AARE) between the calculational and experimental flow stress were used to evaluate the accuracy of the two models. The results show that the effect of dynamic softening on flow stress is much more significant at higher temperatures and lower strain rates, while this effect is not obvious when the strain rate exceeds 0.005 s−1 with the temperature below Ac3. The MJC model has a good accuracy close to the reference conditions (0.001 s−1 and 700 °C), and it is suitable to predict the plastic behavior when the flow stress is lower than 200 Mpa. The unbiased AARE values were 6.82 and 5.71 for MJC model and SCA model, respectively, which implied the SCA model has a higher accuracy than the MJC model. The SCA model was believed to be capable of being used to illustrate the thermomechanical behavior of 5CrNiMoV tool steel in a wide range of plastic deformation conditions.

8 June 2026 in Journal of Iron and Steel Research International
Verified
Journal Article
Closed access
PDF file
PZPengpeng Zuo
Pengpeng Zuo
HZHai-Lan Zhao
Hai-Lan Zhao
XCXin-Yu Chen
Xin-Yu Chen
HWHong-Qing Wu
Hong-Qing Wu
SLShaohong Li
Shaohong Li
JLJun-Wan Li
Jun-Wan Li