Currently there is considerable interest in developments leading to new advanced high-strength sheet steels (AHSS) for automotive and other transportation applications that demand high strength, light weight materials. Design requirements will involve material properties with strengths greater than currently available dual phase and transformation-induced plasticity (TRIP) steels (steels in this group are referred to as the “First Generation” of AHSS), with good ductility and formability, but produced at a cost less than the high ductility stainless steels or high manganese TWIP steels (materials referred to as the “Second Generation” of AHSS). Recent studies have shown that materials that satisfy the required property/cost combinations will include complex microstructures containing high amounts of retained austenite in combination with a high strength constituent that may be ultrafine grained ferrite, martensite, bainite, and/or combinations of ferrite-based constituents. In this article, selected methodologies leading to the production of new AHSS materials will be reviewed and assessed to provide a framework for consideration of new concepts and processing routes that will be required in production operations.
This paper highlights some recent efforts to extend the use of medium-Mn steels for applications other than intercritically batch-annealed steels with exceptional ductility (and strengths in the range of about 1000 MPa). These steels are shown to enable a range of promising properties. In hot-stamping application concepts, elevated Mn concentration helps to stabilize austenite and to provide a range of attractive property combinations, and also reduces the processing temperatures and likely eliminates the need for press quenching. The “double soaking” concept also provides a wide range of attractive mechanical property combinations that may be applicable in cold-forming applications, and could be implemented in continuous annealing and/or continuous galvanizing processes where Zn-coating would typically represent an additional austempering step. Quenching and partitioning of steels with elevated Mn concentrations have exhibited very high strengths, with attractive tensile ductility; and medium-Mn steels have been successfully designed for quenching and partitioning using room temperature as the quench temperature, thereby effectively decoupling the quenching and partitioning steps.
With the development of new steels and processing techniques, there have been corresponding advances in the fatigue performance of automotive components. These advances have led to increased component life and smaller power transfer systems. New processing approaches to enhance the fatigue performance of steels are reviewed with an emphasis on carburizing and deep rolling. Selected examples are presented to illustrate the importance of the base steel properties on the final performance of surface modified materials. Results on carburized gear steels illustrate the dependence of the fatigue behavior on carburizing process control (gas and vacuum carburizing), alloy additions and microstructure. The importance of retained austenite content, case and core grain size as controlled by processing and microalloy additions, extent of intergranular oxidation, and the residual stress profile on fatigue performance is also illustrated. Specific recent results on the use of microalloying elements (e.g. Nb) and process history control to limit austenite grain growth at the higher carburizing temperatures associated with vacuum carburizing are highlighted. For crankshaft applications, deep rolling is highlighted, a process to mechanically work fillet surfaces to improve fatigue resistance. The influence of the deformation behavior of the substrate, as characterized by standard tensile and compression tests, on the ability to create desired surface properties and residual stress profiles will be illustrated with data on several new steels of current and future interest for crankshaft applications