Extensive research efforts are underway globally to develop new steel microstructure concepts for high-strength sheet products, driven largely by the need for lightweight automotive structures in support of designs to enhance occupant safety and energy efficiency. One promising approach, involving the quenching and partitioning (Q&P) process, was introduced in the predecessor to this paper series, Austenite Formation and Decomposition, 2003.[1] Development of the Q&P process has continued through to the present, and the current status is highlighted in this article, along with some alternative approaches that are also receiving attention. Special emphasis is placed on the synthesis and interpretation of the fundamental phase transformation responses, perspectives related to alloying and processing, and the resulting microstructure and properties. Key mechanistic issues are discussed, including carbide formation and suppression, migration of the martensite/austenite interface, carbon partitioning, and partitioning kinetics.
Tempering of martensite in the absence of carbide precipitation leads to carbon partitioning into retained austenite. If the martensite/austenite interface is assumed to remain stationary during this process, the phase compositions reach a condition that has recently been called constrained carbon equilibrium. If iron atoms are sufficiently mobile at the interface, longer partitioning times may lead to migration of the ferrite/austenite interface. The interface may be expected to move in either direction, depending on the specific details of the phase fractions and compositions controlling the chemical potential of iron at the interface. If interface migration occurs during carbon partitioning, the situation is more complicated and conditions could exist where the interface moves first in one direction and then the other.
This paper highlights some recent efforts to extend the use of medium-Mn steels for applications other than intercritically batch-annealed steels with exceptional ductility (and strengths in the range of about 1000 MPa). These steels are shown to enable a range of promising properties. In hot-stamping application concepts, elevated Mn concentration helps to stabilize austenite and to provide a range of attractive property combinations, and also reduces the processing temperatures and likely eliminates the need for press quenching. The “double soaking” concept also provides a wide range of attractive mechanical property combinations that may be applicable in cold-forming applications, and could be implemented in continuous annealing and/or continuous galvanizing processes where Zn-coating would typically represent an additional austempering step. Quenching and partitioning of steels with elevated Mn concentrations have exhibited very high strengths, with attractive tensile ductility; and medium-Mn steels have been successfully designed for quenching and partitioning using room temperature as the quench temperature, thereby effectively decoupling the quenching and partitioning steps.
Recent research efforts to develop advanced–/ultrahigh–strength medium-Mn steels have led to the development of a variety of alloying concepts, thermo-mechanical processing routes, and microstructural variants for these steel grades. However, certain grades of advanced–/ultrahigh–strength steels (A/UHSS) are known to be highly susceptible to hydrogen embrittlement, due to their high strength levels. Hydrogen embrittlement characteristics of medium–Mn steels are less understood compared to other classes of A/UHSS, such as high Mn twinning–induced plasticity steel, because of the relatively short history of the development of this steel class and the complex nature of multiphase, fine-grained microstructures that are present in medium–Mn steels. The motivation of this paper is to review the current understanding of the hydrogen embrittlement characteristics of medium or intermediate Mn (4 to 15 wt pct) multiphase steels and to address various alloying and processing strategies that are available to enhance the hydrogen-resistance of these steel grades.