During the last years, pharmaceutical innovations in primary care are dramatically less frequent and will be even more rare in the next future. In this context, preclinical and clinical research oriented their interest toward natural compounds efficacy and safety, supporting the development of a new “nutraceutical” science. Medicinal plants, in the form of plant parts or extracts of them, are commonly used for the treatment of prostate diseases such as benign hypertrophy, prostatitis and chronic pelvic pain syndrome. The pharmacological properties searched for the treatment of prostatic diseases are anti-androgenic, anti-estrogenic, antiproliferative, antioxidant and anti-inflammatory. The most studied and used medicinal plants are Serenoa repens, Pygeum africanum and Urtica dioica. Other promising plants are Cucurbita pepo, Epilobium spp, Lycopersum esculentum, Secale cereale, Roystonea regia, Vaccinium macrocarpon. In parallel, epidemiological studies demonstrated that diet may play an important role on incidence and development of prostatic diseases. The Mediterranean diet is rich of elements with anti-oxidant properties that act as a protective factor for prostatic cancer. Similarly, low intake of animal protein, high intake of fruits and vegetable, lycopene and zinc are a protective factor for benign prostatic hyperplasia (BPH). Serenoa repens in the treatment of symptoms of BPH has been tested either alone or, more frequently, in combination with other medicinal plants, alpha-blockers and inhibitors of 5- alpha reductase (5-ARI). Recent meta-analyses found the effectiveness of Serenoa repens similar or inferior of that of finasteride and tamsulosin but clearly higher than that of placebo in the treatment of mild and moderate low urinary tract symptoms (LUTS), nocturia and discomfort. Clinical trials showed potential synergistic effect of Serenoa repens with other medicinal plants and drugs. In addition to Serenoa repens, there are many other medicinal plants for which clinical evidence is still controversial. Urtica dioica, Pygeum africanum and Curcubita pepo can be considered as an adjunct to the common therapies and their use is supported by studies showing improvement of symptoms and flowmetric indices. Lycopene and selenium are natural products with antioxidant and anti-inflammatory action. The combination of lycopene and selenium with Serenoa repens was able to reduce inflammation in histological prostate sections and to further improve symptom scores and urinary flow in patients with BPH on tamsulosin treatment. Similar effects could be obtained with the use of other carotenoids, such as astaxanthin, and/or zinc. Efficacy on symptoms of patients with BPH of some polyphenols such as quercitin, equol and curcumin have been demonstrated by clinical studies. Pollen extract is a mixture of natural components able to inhibit several cytokines and prostaglandin and leukotriene synthesis resulting in a potent anti-inflammatory effect. Pollen extracts significantly improve symptoms, pain, and quality of life in patients affected by chronic pelvic pain syndrome and chronic prostatitis. Beta-sitosterol is a sterol able to improve urinary symptoms and flow measures, but not to reduce the size of the prostate gland. Palmitoylethanolamide (PEA) is an endogenous fatty acid amide-signaling molecule with anti-inflammatory and neuroprotective effects that can have an interesting role in the management of chronic pelvic pain syndrome and chronic urological pain. Finally, several plant-based products have been subjected to preclinical, in vitro and in vivo, investigations for their potential pharmacological activity against prostate cancer. Some epidemiological studies or clinical trials evaluated the effects of beverages, extracts or food preparations on the risk of prostate cancer. Some plant species deserved more intense investigation, such as Camelia sinensis (green or black tea), Solanum lycopersicum (common tomato), Punica granatum (pomegranate), Glycine max (common soy) and Linum usitatissimum (linen).

Natural deep eutectic solvents (NaDES) represent a new generation of green, non-flammable solvents, useful as an efficient alternative to the well-known ionic liquids. They can be easily prepared and exhibit unexpected solubilizing power for lipophilic molecules, although those of a hydrophilic nature are mostly used. For their unique properties, they can be recommend for different cosmetic and pharmaceutical applications, ranging from sustainable extraction, obtaining ready-to-use ingredients, to the development of biocompatible drug delivery responsive systems. In the biomedical field, NaDES can be used as biopolymer modifiers, acting as delivery compounds also known as “therapeutic deep eutectic systems”, being able to solubilize and stabilize different chemical and galenical formulations. The aim of this review is to give an overview of the current knowledge regarding natural deep eutectic solvents specifically applied in the cosmetic and pharmaceutical fields. The work could help to disclose new opportunities and challenges for their implementation not only as green alternative solvents but also as potential useful pathways to deliver bioactive ingredients in innovative formulations.

Rosa x damascena Mill. essential oil is mainly used in the cosmetics and perfumery industry, but it also finds application in the food industry as a flavoring agent. The chemical composition of essential oils is affected by environment, soil, harvesting technique, storage condition, and extraction methods. Nowadays, the study and design of greener, more efficient, and sustainable extractive procedures is the main and strategic focus in the chemical research and development of botanical derivatives, especially as regards fragrances and essential oils. Several technologies are available, and the best method to use depends on the desired chemicals, but conventional extractive processes are often laborious and time-consuming, involve large amounts of solvents, and may cause the partial loss of volatiles, affecting the quality of the final product. In the last decade, microwave irradiation has been successfully applied to classical techniques, often improving the general extractive efficiency and extract quality. In the present paper, as a preliminary analytical screening approach, two microwave-mediated techniques, Solvent-Free Microwave Extraction (SFME) and Microwave Hydrodiffusion and Gravity (MHG), and two conventional procedures, Hydrodistillation (HD) and Steam Distillation (SD), were applied and compared for the extraction of volatile compounds from R. x damascena fresh petals to highlight differences and advantages of the selected procedure and of the obtained extracts useful in a cosmetic context as fragrances or active ingredients. The chemical composition of the extracts was investigated by GC-MS and GC-FID. Sixty-one components, distributed in the four techniques, were identified. SD and HD are dominated by oxygenated terpenes (59.01% and 50.06%, respectively), while MHG and SFME extracts are dominated by alcohols (61.67% and 46.81%, respectively). A relevant variability in the composition of the extracts relating to the extraction techniques used was observed. To point out the correlation between the process and composition of the obtained natural products, principal component analysis (PCA) of the data extracted from GC-FID was used. Taking into account a cosmetic application, SFME shows several advantages when compared with the other procedures. The extract (obtained in a significantly higher amount) contains a meaningful lower level of potential fragrance allergenic compounds and quite a double amount of benzyl alcohol and 2-phenyl ethanol that can also enhance the preservative action in personal care products.

The volatile fractions from fresh inflorescences of naturally growing orchids Anacamptis coriophora (L.) R. M. Bateman, Pridgeon & M. W. Chase subsp. fragrans (Pollini), Anacamptis pyramidalis (L.) R. Ophrys holosericea (Burm.) Greuter and Serapias vomeracea (Burm. f.) B. were isolated by steam distillation and analyzed by GC/FID and GC/MS. Saturated hydrocarbons were quantified as the major constituents of the volatile fraction (47.87–81.57% of the total essential oil), of which long-chain monounsaturated hydrocarbons accounted from 9.20% to 32.04% of the total essential oil. Double bond position in linear alkenes was highlighted by dimethyl disulfide derivatization and MS fragmentation. Aldehydes (from 3.45 to 18.18% of the total essential oil), alcohols (from 0.19% to 13.48%), terpenes (from 0.98 to 2.50%) and acids (0.30 to 2.57%) were also detected. These volatiles compounds may represent a particular feature of these plant species, playing a critical role in the interaction with pollinators. DPPH assay evaluating the antioxidant activity of the essential oils was carried out, showing a dose-dependent antioxidant activity.

In the present study, surface contamination where antineoplastic drugs (ADs) are present was investigated, as occupational exposure risk is still an open debate. Despite recommendations and safety standard procedures being in place in health care settings, quantifiable levels of ADs are being reported in the recent literature. Thus, a survey monitoring program was conducted over five years (2016–2021) in nine Italian hospitals. The repeated surveys produced 8288 data points that have been grouped according to the main hospital settings, such as pharmacy areas and patient care units. Based on the most often prepared ADs, the investigated drugs were cyclophosphamide (CP), gemcitabine (GEM), 5-fluorouracil (5–FU), and platinum compounds (Pt). Patient care units had a frequency of positive wipe samples (59%) higher than pharmacies (44%). Conversely, pharmacies had a frequency of positive pad samples higher (24%) than patient care units (10%). Moreover, by statistical analysis, pad samples had a significantly higher risk of contamination in pharmacy areas than in patient care units. In this study, the 75th and the 90th percentiles of the contamination levels were obtained. The 90th percentile was chosen to describe a suitable benchmark that compares results obtained by the present research with those previously reported in the literature. Based upon surface contamination loads, our data showed that 5–FU had the highest concentration values, but the lowest frequency of positive samples. In pharmacy areas, the 90th percentile of 5–FU data distribution was less than 0.346 ng/cm² and less than 0.443 ng/cm² in patient care units. AD levels are higher than those reported for health care settings in other European countries yet trends of contamination in Italy have shown to decrease over time.

A detailed chemical composition of Dendrobium essential oil has been only reported for a few main species. This article is the first to evaluate the essential oil composition, obtained by steam distillation, of five Indian Dendrobium species: Dendrobium chrysotoxum Lindl., Dendrobium harveyanum Rchb.f., and Dendrobium wardianum R.Warner (section Dendrobium), Dendrobium amabile (Lour.) O’Brien, and Dendrobium chrysanthum Wall. ex Lindl. (section Densiflora). We investigate fresh flower essential oil obtained by steam distillation, by GC/FID and GC/MS. Several compounds are identified, with a peculiar distribution in the species: Saturated hydrocarbons (range 2.19–80.20%), organic acids (range 0.45–46.80%), esters (range 1.03–49.33%), and alcohols (range 0.12–22.81%). Organic acids are detected in higher concentrations in D. chrysantum, D. wardianum, and D. harveyanum (46.80%, 26.89%, and 7.84%, respectively). This class is represented by palmitic acid (13.52%, 5.76, and 7.52%) linoleic acid (D. wardianum 17.54%), and (Z)-11-hexadecenoic acid (D. chrysantum 29.22%). Esters are detected especially in species from section Dendrobium, with ethyl linolenate, methyl linoleate, ethyl oleate, and ethyl palmitate as the most abundant compounds. Alcohols are present in higher concentrations in D. chrysantum (2.4-di-tert-butylphenol, 22.81%), D. chrysotoxum (1-octanol, and 2-phenylethanol, 2.80% and 2.36%), and D. wardianum (2-phenylethanol, 4.65%). Coumarin (95.59%) is the dominant compound in D. amabile (section Densiflora) and detected in lower concentrations (range 0.19–0.54%) in other samples. These volatile compounds may represent a particular feature of these plant species, playing a critical role in interacting with pollinators.