This general review paper presents a condensed view of recent inventions in the Additive Manufacturing (AM) field. It outlines factors affecting the development and commercialization of inventions via research collaboration and discusses breakthroughs in materials and AM technologies and their integration with emerging technologies. The paper explores the impact of AM across various sectors, including the aerospace, automotive, healthcare, food, and construction industries, since the 1970s. It also addresses challenges and future directions, such as hybrid manufacturing and bio-printing, along with socio-economic and environmental implications. This collaborative study provides a concise understanding of the latest inventions in AM, offering valuable insights for researchers, practitioners, and decision makers in diverse industries and institutions.

Fused Filament Fabrication (FFF), classified under material extrusion additive manufacturing technologies, is a widely used method for fabricating thermoplastic parts with high geometrical complexity. To improve the mechanical properties of pure thermoplastic materials, the polymeric matrix may be reinforced by different materials such as carbon fibers. FFF is an advantageous process for producing polymer matrix composites because of its low cost of investment, high speed and simplicity as well as the possibility to use multiple nozzles with different materials. In this study, the aim was to investigate the dimensional accuracy and mechanical properties of chopped carbon-fiber-reinforced tough nylon produced by the FFF process. The dimensional accuracy and manufacturability limits of the process are evaluated using benchmark geometries as well as process-inherent effects like stair-stepping effect. The hardness and tensile properties of produced specimens in comparison to tough nylon without any reinforcement, as well as continuous carbon-reinforced specimens, were presented by taking different build directions and various infill ratios. The fracture surfaces of tensile specimens were observed using a Scanning Electron Microscope (SEM). The test results showed that there was a severe level of anisotropy in the mechanical properties, especially the modulus of elasticity, due to the insufficient fusion between deposited layers in the build direction. Moreover, continuous carbon-reinforced specimens exhibited very high levels of tensile strength and modulus of elasticity whereas the highest elongation was achieved by tough nylon without reinforcement. The failure mechanisms were found to be inter-layer porosity between successive tracks, as well as fiber pull out.

Additive manufacturing has revolutionised the production of functional components and assemblies, offering a high degree of manufacturing flexibility. This review explores the latest advancements in additive manufacturing, focusing on its fusion-based and solid-state based technologies, and highlights the use of recycled aluminium as feedstock in these processes. The advantages and limitations of incorporating recycled materials are thoroughly analysed, considering factors such as material properties, sustainability, and process acceptance. While up to 14.4 kg CO₂ per kg of aluminium is released during primary aluminium ingot production, solid-state based additive manufacturing, which is tolerant of feedstock contamination, can directly recycle aluminium. Meanwhile, fusion based additive manufacturing can readily utilise recycling pathways such as maintaining grade, upcycling, and downcycling, as well as powder reuse, providing opportunities for significant emissions reduction. The examination of feedstock manufacturing in this review, such as wire for WAAM and powder for PBF, indicates that this step indirectly increases the resource consumption of additive manufacturing. Finally, the alignment of aluminium recycling and additive manufacturing with Circular Economy principles and the UN's sustainable development goals are addressed, highlighting contributions to SDGs 3, 9, and 12.