A numerical 3D procedure is presented based on the Finite Volume Method to solve the governing equations of Proton Exchange Membrane Fuel Cell (PEMFC) with rhombus design. We evaluated these equations in both the anode and cathode gas channels. In the present research, we examined the impact of rhombus design on the output characteristics of PEMFC under appropriate operating conditions and verified the outputs with experimental data. The water accumulation has a significant effect on fuel cell performance. We studied different aspects of the fuel cell to obtain the water accumulation and characteristics’ distribution of fluid flow in the gas channel and their influence on the performance of PEMFC. The current intensity and power density are the most critical elements of a fuel cell. Model B has increased the current density by one compared to the base model. The cell power consumption has been reduced by 1/4 and 1/8 ratios. The pressure drop in the presented models has been significantly reduced and controlled. The electrical power generated by Model B is 1.5 higher than the base model. Proton Exchange Membrane Fuel Cell (PEMFC) governing equations.
23 August 2012 in Journal of Mechanical Science and Technology
The performance of proton-exchange membrane (PEM) fuel cells is strongly dependent on the geometry, flow channel configuration, and size. The present work numerically studies the performance of PEM fuel cells through the design of gas injection channels of different geometries. Computational fluid dynamics was adopted to solve the governing equations. The finite volume method was used to discretize and solve the equations. The channel geometries included spiral quasi (Model A), parallel (Model B), and pin (Model C), which have the same dimensions as the base serpentine model. The performance of the system was validated using the base model, and the simulation was carried out at a voltage of 0.6 V. The present study primarily aimed to utilize novel PEM fuel cell designs and improve their performance. The highest current density and output power were found to occur in Model C, whereas Model B had the lowest current density and output power. The temperature distribution was uniform in Model C and the base model. Moreover, Model C had the lowest water production; therefore, water immersion would not interrupt the fuel cell. On the other hand, Model B was observed to experience the largest liquid water generation, leading to an interrupted fuel cell. Model C had the lowest pressure loss and, therefore, lower power was required to pump gasses through the channel. It was found that Models C and B had the highest and lowest performances, respectively.
2 April 2018 in International Journal of Energy Research