The increased use of engineered nanoparticles (ENPs), such as copper oxide nanoparticles (CuO NPs), in commercial products and applications raises concern regarding their possible release into freshwater sources. Therefore, their removal from water is important to eliminate adverse environmental and human health effects. In this study, the effects of pH and natural organic matter (NOM), i.e., humic acid (HA) and salicylic acid (SA) on the removal of CuO NPs by coagulation/flocculation/sedimentation (C/F/S) were evaluated. The results indicated that pH significantly affects the coagulation efficiency, where 10–60% CuO NPs removal was achieved under extreme acidic/alkaline conditions. However, at neutral pH, removal of up to 90% was observed with a lower ferric chloride (FC) dosage (0.2 mM). The coagulation efficiency and mechanism were strongly affected by the type of Fe species present in the aqueous phase, which is mainly controlled by pH. Higher concentrations of both HA and SA decrease the CuO NPs agglomeration rate, and thereby improve the colloidal stability due to the NOM molecules adsorbed onto the NPs surface. The presence of hydrophobic HA needs a higher FC dosage of 0.5–0.8 mM than a dosage of hydrophilic SA of 0.25–0.35 mM, to obtain a similar CuO coagulation efficiency. Moreover, higher removals of dissolved organic carbon (DOC) and UV₂₅₄ were observed more in hydrophobic NOM than in hydrophilic. The results of the Fourier transform infrared (FT-IR) analysis of FC composite flocs confirm that the charge neutralization and enmeshment of coagulant might be a possible removal mechanism. The findings of the current study may provide critical information in the prediction of the fate, mobility, and removal of CuO NPs during C/F/S in water treatment.

The increased use of copper oxide nanoparticles (CuO NPs) in commercial products and industrial applications raises concerns about their adverse effects on aquatic life and human health. Therefore, the current study explored the removal of CuO NPs from water via coagulation by measuring solubility under various pH values and humic acid (HA) concentrations. The results showed that the media pH significantly affected the coagulation efficiency of CuO NPs (30 mg/L) under various (0–0.30 mM) ferric chloride (FC) dosages. The concentration of dissolved Cu²⁺ ions at pH 3–6 was (16.5–4.8 mg/L), which was higher than at other studied pH (7–11). Moreover, the simultaneous effect of coagulants and charge neutralization at pH 6–8 enhanced the removal of CuO NPs. At a lower FC (0–0.05 mM) dosage, the higher HA concentration inhibited the aggregation of CuO NPs. However, at the optimum dose of (0.2 mM) FC, the efficiency of turbidity removal and solubility of CuO NPs between pH 8 and 11 was above 98% and 5%, respectively, probably due to coagulant enmeshment. Our study suggested that coagulation was effective in removing the CuO NPs from the complex matrices with pH values ranging from 8–11. The findings of the present study provide insight into the coagulation and dissolution behavior of CuO NPs during the water treatment process.

The large-scale production and usage of zinc oxide nanoparticles (ZnO NPs) may lead to their post-release into the aquatic environment. In this study, the effect of hydrophobic/hydrophilic organic ligands on sorption and sedimentation of ZnO NPs has been systematically investigated. In addition, the coagulation efficiency of ZnO NPs, Zn²⁺, dissolved organic carbon (DOC), and UV₂₅₄ with varying ferric chloride (FC) dosages in synthetic waters were also evaluated. The results showed that the higher concentration of organic ligands, i.e., humic acid (HA), salicylic acid (SA), and L-cysteine (L-cys) reduced the ζ-potential and hydrodynamic diameter (HDD) of particles, which enhanced the NPs stability. The adsorption of organic ligands onto ZnO NPs was fitted with the Langmuir model, with maximum adsorption capacities of 143, 40.47, and 66.05 mg/g for HA, SA and L-cys respectively. Removal of up to 95% of ZnO NPs and Zn²⁺ was achieved in studied waters at the effective coagulation zone (ECR), above which excess charge induced by coagulant restabilized the NPs in suspension. Moreover, the removal rate of DOC and UV₂₅₄ were found to be higher in hydrophobic waters than hydrophilic waters. The width of ECR strongly depends on the characteristics of source water. The waters with hydrophobic ligand and higher UV₂₅₄ values require more coagulant than hydrophilic waters to achieve the similar ZnO NPs and Zn²⁺ removal. The results of Fourier transform infrared (FT-IR) analysis of ZnO NPs composite contaminant flocs indicated that the combined effect of enmeshment and charge neutralization might be a possible removal mechanism. These findings may facilitate the prediction of fate, transport, and removal of ZnO NPs in the natural waters, and might contribute to risk assessment, as well as decision making about engineered nanoparticles (ENPs) in aquatic systems.

Arsenic (As)-laden wastewater may pose a threat to biodiversity when released into soil and water bodies without treatment. The current study investigated the sorption properties of both As(III, V) oxyanions onto iron hydroxide (FHO) by chemical coagulation. The potential mechanisms were identified using the adsorption models, ζ-potential, X-ray diffraction (XRD) and Fourier Transform Infrared Spectrometry (FT-IR) analysis. The results indicate that the sorption kinetics of pentavalent and trivalent As species closely followed the pseudo-second-order model, and the adsorption rates of both toxicants were remarkably governed by pH as well as the quantity of FHO in suspension. Notably, the FHO formation was directly related to the amount of ferric chloride (FC) coagulant added in the solution. The sorption isotherm results show a better maximum sorption capacity for pentavalent As ions than trivalent species, with the same amount of FHO in the suspensions. The thermodynamic study suggests that the sorption process was spontaneously exothermic with increased randomness. The ζ-potential, FT-IR and XRD analyses confirm that a strong Fe-O bond with As(V) and the closeness of the surface potential of the bonded complex to the point of zero charge (pH_zpc) resulted in the higher adsorption affinity of pentavalent As species than trivalent ions in most aquatic conditions. Moreover, the presence of sulfates, phosphates, and humic and salicylic acid significantly affected the As(III, V) sorption performance by altering the surface properties of Fe precipitates. The combined effect of charge neutralization, complexation, oxidation and multilayer chemisorption was identified as a major removal mechanism. These findings may provide some understanding regarding the fate, transport and adsorption properties onto FHO of As oxyanions in a complex water environment.

The co-occurrence of arsenic (As) and organic ligands in water bodies has raised environmental concerns due to their toxicity and adverse effects on human health. The present study aims to elucidate the influences of hydrophobic/hydrophilic organic ligands, such as humic acid (HA) and salicylic acid (SA), on the interactive behavior of As species in water. Moreover, the competitive removal behaviors of As(III, V) species and total organic carbon (TOC) were systematically investigated by coagulation-flocculation-sedimentation (C/F/S) under various aqueous matrices. The results showed the stronger binding affinity of As(V) than As(III) species, with a higher complexation ability of hydrophobic ligands than hydrophilic. The media containing hydrophilic ligands require smaller ferric chloride (FC) doses to achieve the higher As(III, V) removal, while the optimum FC dose required for As(III) removal was found to be higher than that for As(V). Moreover, hydrophobic ligands showed higher TOC removal than hydrophilic ligands. The pronounced adverse effect of a higher concentration of hydrophobic ligands on the removal efficiencies of As(V) and TOC was observed. The adsorption of As(V) on Fe precipitates was better fitted with the Langmuir model but the Freundlich isotherm was more suitable for As(III) in the presence of hydrophilic SA. Moreover, TOC removal was substantially decreased in the As(V) system as compared to the As(III) system due to the dissolution of Fe precipitates at higher As(V) concentrations. The results of FC composite flocs demonstrated that the combined effect of oxidation, charge neutralization and adsorption played an important role in the removal of both toxicants during the C/F/S process. In summary, the findings of the present study provide insights into the fate, mobility and competitive removal behavior of As(III, V) species and organic ligands in the water treatment process.

Coprecipitation-adsorption plays a significant role during coagulation-flocculation-sedimentation (C/F/S) of antimony (Sb) in water. This work uses a Box–Behnken statistical experiment design (BBD) and response surface methodology (RSM) to investigate the effects of major operating variables such as initial Sb(III, V) concentration (100–1000 µg/L), ferric chloride (FC) dose (5–50 mg/L), and pH (4–10) on redox Sb species. Experimental data of Sb(III, V) removal were used to determine response function coefficients. The model response value (Sb removal) showed good agreement with the experimental results. FC showed promising coagulation behavior of both Sb species under optimum pH (6.5–7.5) due to its high affinity towards Sb species and low residual Fe concentration. However, a high dose of 50 mg/L of FC is required for the maximum (88–93%) removal of Sb(V), but also for the highest (92–98%) removal of low initial concentrations of Sb(III). Furthermore, BBD and RSM were found to be reliable and feasible for determining the optimum conditions for Sb removal from environmental water samples by a C/F/S process. This work may contribute to a better understanding and prediction of the C/F/S behavior of Sb(III, V) species in aqueous environments, to reduce potential risks to humans.