Li Song

Dr. Li Song


Research Focus & Metrics

Academic Career Length

14Years (2013-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 March 2020 in Construction and Building Materials
Verified
Journal Article
Closed access
LSLi Song
Li Song
HLHubing Liu
Hubing Liu
CCChenxing Cui
Chenxing Cui
ZYZhiwu Yu
Zhiwu Yu
ZLZhigang Li
Zhigang Li

1 January 2016 in Construction and Building Materials
Verified
Journal Article
Closed access
Peng LiuPeng Liu
Peng Liu
LSLi Song
Li Song
ZYZhiwu Yu
Zhiwu Yu

29 April 2022 in Construction and Building Materials
Verified
Journal Article
Closed access
JLJintao Liu
Jintao Liu
LSLi Song
Li Song
LWLei Wu
Lei Wu
RLRan Liu
Ran Liu
ZYZhiwu Yu
Zhiwu Yu

1 January 2015 in Advances in Materials Science and Engineering
Verified
Journal Article
Open access
PDF file
JHJian Hou
Jian Hou
LSLi Song
Li Song
Pitting corrosion has been observed in steel bars of existing reinforced concrete (RC) structures in different erosion environments and has been identified as a potential origin for fatigue crack nucleation. In the present study, under uniaxial tension loading, stress distribution in the steel bars with one or two semiellipsoidal corrosion pits has systematically been investigated by conducting a series of three-dimensional semiellipsoidal pitted models. Based on the finite element analyses, it is shown that stress concentration factor (SCF) increases linearly with increasing pit aspect ratio (a/b) and increases nonlinearly with increasing pit relative depth (a/R) for single corrosion pit problem. For double corrosion pits problem, the SCF decreases nonlinearly with increasing angle of two transverse pits (θ). The interaction of two longitudinal pits can be ignored in the calculation of SCF even if the distance of two pits (d) is very small.

1 January 2013 in Applied Mechanics and Materials
Verified
Journal Article
Closed access
PDF file
ZWZong Shen Wang
Zong Shen Wang
YGYanjin Guan
Yanjin Guan
LSLi Song
Li Song
PLPing Liang
Ping Liang
Improvement of materials properties induced by constrained groove pressing (CGP) depends largely on deformation homogeneity. Utilizing commercial software DEFORM-3D, a finite element model of multi-pass CGP was established. The distribution and homogeneity evolution of equivalent strain ware analyzed in detail. Based on Taguchi optimization method, the influence of processing parameters (such as groove width, groove angle, friction coefficient and deformation rate) on strain homogeneity was studied numerically and systematically. Within a certain range, the optimum parameter combination is obtained by means of signal to noise ratio analysis. The inhomogeneity factor of the optimum model decreases by about 50 %. The average accumulative equivalent strain is almost twice that of the initial model. Analysis of variance shows that groove angle and groove width are the two most important parameters and effect of friction between dies and sample should not be neglected.