Maurizio Santini

Prof. Maurizio Santini

Department of Engineering and Applied Sciences, University of Bergamo, viale Marconi 5, 24044 Dalmine, Italy
orcid

Research Focus & Metrics

Academic Career Length

22Years (2005-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 February 2008 in International Journal of Heat and Fluid Flow
Verified
Journal Article
Closed access
GCG.E. Cossali
G.E. Cossali
Marco MarengoMarco Marengo
Marco Marengo
Maurizio SantiniMaurizio Santini
Maurizio Santini

1 September 2005 in Experimental Thermal and Fluid Science
Verified
Journal Article
Closed access
GCG.E. Cossali
G.E. Cossali
Marco MarengoMarco Marengo
Marco Marengo
Maurizio SantiniMaurizio Santini
Maurizio Santini

1 July 2017 in Journal of Power Sources
Verified
Journal Article
Closed access
Maurizio SantiniMaurizio Santini
Maurizio Santini
Stefania MARZORATIStefania MARZORATI
Stefania MARZORATI
SFStephanie Fest-Santini
Stephanie Fest-Santini
STS. Trasatti
S. Trasatti
PCPierangela Cristiani
Pierangela Cristiani

1 September 2015 in Biointerphases
Verified
Journal Article
Closed access
Maurizio SantiniMaurizio Santini
Maurizio Santini
Manfredo GuilizzoniManfredo Guilizzoni
Manfredo Guilizzoni
MLMassimo Lorenzi
Massimo Lorenzi
PAPlamen Atanassov
Plamen Atanassov
Enrico MarsiliEnrico Marsili
Enrico Marsili
Carlo SantoroCarlo Santoro
Carlo Santoro
Power output limitation is one of the main concerns that need to be addressed for full-scale applications of the microbial fuel cell technology. Fouling and biofilm growth on the cathode of single chamber microbial fuel cells (SCMFC) affects their performance in long-term operation with wastewater. In this study, the authors report the power output and cathode polarization curves of a membraneless SCMFC, fed with raw primary wastewater and sodium acetate for over 6 months. At the end of the experiment, the whole cathode surface is analyzed through X-ray microcomputed tomography (microCT), scanning electron microscopy, and energy-dispersive X-ray spectroscopy (EDX) to characterize the fouling layer and the biofilm. EDX shows the distribution of Ca, Na, K, P, S, and other elements on the two faces of the cathode. Na-carbonates and Ca-carbonates are predominant on the air (outer) side and the water (inner) side, respectively. The three-dimensional reconstruction by X-ray microCT shows biofilm spots unevenly distributed above the Ca-carbonate layer on the inner (water) side of the cathode. These results indicate that carbonates layer, rather than biofilm, might lower the oxygen reduction reaction rate at the cathode during long-term SCMFC operation.

1 January 2005 in Atomization and Sprays
Verified
Journal Article
Closed access
GCGianpietro Cossali
Gianpietro Cossali
Maurizio SantiniMaurizio Santini
Maurizio Santini
Marco MarengoMarco Marengo
Marco Marengo
Simplified impingement models are largely used in numerical simulation of spray impingement on solid walls, since the direct simulation of multiple drop impact is outside of the present computer capabilities. These models are usually semiempirical, based on single-drop impact experimental data and some reasonable constraints to allow extrapolation to different impact conditions. This article presents a comparison of the most commonly used drop impingement models in the present scientific literature and in commercial codes. A classification of the models and a unified scheme is proposed in terms of driving variables and outcomes. Every model is then analyzed and its peculiarities and possible weaknesses are pointed out, especially those related to the physical consistency. Finally, a comparison among the various models for a possible use in Gasoline Direct Injection (GDI) and diesel spray simulation is presented.

1 November 2013 in Journal of Colloid and Interface Science
Verified
Journal Article
Closed access
Maurizio SantiniMaurizio Santini
Maurizio Santini
Manfredo GuilizzoniManfredo Guilizzoni
Manfredo Guilizzoni
SFStephanie Fest-Santini
Stephanie Fest-Santini