The optimization of the autogenous diffusion copper bonding via thermocompression at vacuum environment was investigated. The influence of various bonding parameters on the interdiffusion efficiency was studied in detail at the micro (SEM-EBSD) and nano (TEM) scales. Bonding at 1000 °C for 90 min under pressure (10 MPa) presented optimum structural and mechanical results. Under these conditions, interdiffusion phenomena were observed at a significant extent through the swelling transformation of existing fine grains or the formation of equiaxed copper grains with an orientation parallel to the bond interface. Transmission electron microscopy revealed the importance of the grain size of the base material on the bond quality. In the regions with fine-sized copper grains, the formation of small equiaxed recrystallized twins was observed. Their length within the bonding zone was in the order of 200 and 400 nm. On the contrary, in the regions with coarse grains the interdiffusion was poorer. The processing temperature and duration presented a significant effect on the bonding strength (BS). BS exceeded 100 MPa in case of processing conditions of T ≥ 850 °C and t ≥ 60 min, while the maximum BS value achieved (≈180 MPa) was comparable with the respective value of the base material. The microhardness of the optimum bond reached 55 HV—slightly higher in comparison to the hardness of the initial copper material. The results indicated that the proposed thermocompression process is appropriate for the production of Cu-Cu bonded structures that can be potentially used as electrical components under mechanical stress.
11 September 2025 in Earth: Environmental Sustainability
The management of bauxite residue (BR) generated during alumina production, is techno-economically challenging due to its colloidal slurry form, high alkalinity, and elevated concentrations of heavy metals and radionuclides. For every tonne of aluminum produced, 2–3 tonnes of BR are generated, leading to an annual global accumulation of approximately 180 million tonnes. At present, dry disposal (“dry stacking”) has become the most widely adopted management practice, although wet disposal of slurry remains in use in several regions. In this context, the present study assesses the environmental impact and the associated energy consumption of BR management following three different management and valorization practices: the wet disposal of the residue (baseline scenario), the dry disposal followed by the partial use of the dried BR in cement clinkering (current practice of the Greek aluminum industry) and the dry disposal followed by the partial use of the dried BR in a geopolymerization process. Results show that impact categories such as acidification (AC), freshwater eutrophication (FC), ozone depletion (OD), and photochemical ozone formation (POF) decrease by 21.6–77.7% under drying/valorization compared with the baseline. Dry disposal/geopolymer manufacturing presents the lowest possible environmental impact. However, the decrease of the global warming (GW) (by 12.8%), is relatively limited, while CED increases by 54.2% due to geopolymerization. Given the limited number of LCA studies available on bauxite residue management, this study explores key environmental challenges posed by current practices and identifies opportunities for improving sustainability and resource efficiency within the aluminum industry.
15 April 2016 in IOP Conference Series: Materials Science and Engineering
In the current study, the kinetic of the thermal decomposition of a composite diasporic-boehmitic bauxite is investigated under non-isothermal heating conditions by means of thermogravimetric analysis. The calculation of activation energy (Ea) has been performed by various methods and the attained values range from 185000 to 190000 J•mol-1 for conversion rate of 0.5. The first-order kinetic model can adequately be used to describe thermal decomposition of bauxite composite, while the pre-exponential factor value was found to be 2.088*1011 min-1.The calculated activation energy value together with pre-exponential factor and the solid state kinetic model factors enable the simulation of the thermal decomposition under various heating conditions by the implementation of an ordinary differential equation. The calculated values are in satisfactory agreement with the experimental ones.