A series of Au films with different nominal deposition thickness d were fabricated on ionic liquid surfaces by thermal evaporation at room temperature, taken as surface-enhanced Raman scattering (SERS) substrates. Au atoms deposited on the liquid surfaces can diffuse and aggregate randomly and eventually form films with ramified structure, which consist of nanoparticles (NPs). There are amounts of ultrasmall (∼ 1 nm or smaller) nanogaps among the Au NPs, which can dramatically enhance Raman signal. Raman spectra of R6G were investigated with the assistance of the Au films. The results indicate that the Au films with higher thickness possess better SERS performance when 5.0 ≤ d ≤ 30.0 nm. A random distribution model of Au NPs was used in the finite-difference time-domain method and the simulation results are in good agreement with the experimental findings.
The microstructure and evolution property of iron thin films deposited on [bmim][BF4] ion liquid surfaces have been studied by annealing method. Ultra fine nanoparticles (NPs) with the size 1.0 to 3.0 nm are observed in the film samples. It is found that, when the annealing temperature Ta increases, the average size of the NPs, i.e., Φ, increases gradually for Ta ≤ 500℃ and it goes up significantly if Ta ≥ 600℃. We find that the size Φ can reach more than 100 nm when Ta = 700℃. Our experiment shows that the growth of the NPs results mainly from capturing nearby atoms and coalescing with the surrounding NPs.
This study presents the design and analysis of a self-assembled, triangular straw-based centrifugal pump. A combined theoretical and experimental approach was employed to systematically investigate its pumping mechanism and performance. The effects of key geometric parameters—tube length, inner diameter, and inclination angle—along with the rotational angular velocity on the volumetric flow rate were quantified. The theoretical framework integrates centrifugal force dynamics, Bernoulli’s principle, and a comprehensive fluid resistance model accounting for both frictional and local losses. Experimental validation was performed using a custom-built apparatus equipped with a precision rotation control system and a flow measurement setup, testing a series of 3D-printed straw specimens with varying dimensions. The results indicate that the flow rate increases with angular velocity and the square of the tube diameter, shows an approximate linear dependence on tube length, and requires exceeding a critical angular velocity for pump initiation. This work establishes a predictive model and provides empirical data to guide the design and optimization of such low-cost, easily fabricated micro-scale pumping devices.