Visible light communication (VLC) is a promising candidate for high-speed wireless communication with numerous unlicensed spectrum. To achieve high-speed data communication, it requires intense light signals concentrated on a tiny fast photodiode. The common way of using focusing optics reduces the field of view (FoV) of the photodiode due to the conservation of étendue. Luminescent solar concentrators (LSC) provide a solution to enhance the signals without affecting the FoV. In this paper we demonstrate nanopatterned LSCs fabricated on flexible plastics that achieve a doubling of optical gain compared to its traditional rectangular counterparts. These LSCs can free VLC detectors from complex active pointing and tracking systems, making them compatible with smart mobile terminals in a simple fashion.
The lack of highly efficient, durable, and cost‐effective electrocatalysts for the hydrogen evolution reaction (HER) working at high current densities poses a significant challenge for the large‐scale implementation of hydrogen production from renewable energy. Herein, amorphous molybdenum tungsten sulfide/nitrogen‐doped reduced graphene oxide nanocomposites (a‐MoWSx/N‐RGO) are synthesized by plasma treatment for use as high‐performance HER catalysts. By adjusting the plasma treatment duration and chemical composition, an optimal a‐MoWSx/N‐RGO catalyst is obtained, which exhibits a low overpotential of 348 mV at a current density of 1000 mA cm−2 and almost no decay after 24 h of working at this current density, outperforming commercial platinum/carbon (Pt/C) and previously reported heteroatom‐doped MoS2‐based catalysts. Based on density functional theory (DFT) calculations, it is found that with a reasonable tungsten doping level, the catalytic active site (2S2 − ) shows excellent catalytic performance working at high current densities because extra electrons preferentially fill at 2S2 − . The introduction of tungsten tends to lower the electronic structure energy, resulting in a closer‐to‐zero positive . Excessive tungsten introduction, however, can lead to structural damage and a worse HER performance under high current densities. The work provides a route towards rationally designing high‐performance catalysts for the HER at industrial‐level currents using earth‐abundant elements.
Room temperature recrystallization is an intriguing method of fabricating CsPbX3 perovskite quantum dots since it does not involve high temperature or inert atmosphere, offering a promising route to the mass production of CsPbX3 quantum dots at low cost. However, their performance stability during work was seldom investigated and was far from the requirements for practical applications. Here, we demonstrate a facile and low-cost method to significantly improve the thermal, photo- and water stability of room-temperature synthesized perovskite quantum dots by effectively suppressing the unfavored grain growth and surface trap states. The fabricated quantum dots of green-emitting CsPbBr3 and red-emitting CsPbBr1.2I1.8 were applied for quantum dot-converted white LEDs, which are capable of achieving a wide color gamut of 135% NTSC and 101% Rec. 2020.
Halide perovskite materials have rapidly emerged as outstanding optoelectronic materials for solar cells, light-emitting diodes (LEDs), and lasers. Compared to hybrid organic-inorganic perovskites, all-inorganic perovskites have shown unique merits that may contribute to the ultimate goal of developing electrically-pumped lasers. In this paper, we demonstrate a distributed feedback (DFB) resonator using an all-inorganic perovskite thin film as the gain medium. The film has a gain coefficient of 161.1 cm−1 and a loss coefficient of 30.9 cm−1. Excited by picosecond pulses, the microstructured all-inorganic perovskite film exhibits a single-mode emission at 654 nm with a threshold of 33 μJ/cm2. The facile fabrication process provides a promising route towards low-cost single-mode visible lasers for many practical applications.
Electrolytic water splitting using renewable energy sources, such as solar power, provides a green and sustainable approach for hydrogen production. Anion exchange membrane (AEM) electrolyzers present substantial commercial prospects; however, the rate of hydrogen evolution reaction (HER) in alkaline electrolytes is limited by the water dissociation step. In this work, we fabricated an N-doped Ni substrate for loading ultrafine Pt nanoparticles, realizing spatial decoupling of the reaction process to break the limitation of water dissociation, where the N-doped Ni substrate and Pt nanoparticles facilitate the supply of ample H* and H2 release, respectively. The prepared Pt–N–Ni/NC with extremely low Pt loading (1.0 wt%) requires only 15 and 149 mV overpotentials to reach current densities of 10 and 1000 mA cm−2, respectively. When assembled into an AEM electrolyzer, the system requires a cell voltage of only 1.75 V to achieve a current density of 1000 mA cm−2. Notably, the solar-driven AEM electrolyzer demonstrates a current density of 1390 mA cm−2 with a solar-to-hydrogen efficiency (STH) of 8.27%. This study proposes a strategy to achieve efficient utilization and performance improvement of precious metals, promoting the development of efficient green hydrogen production.
Raspberry-like structure, providing a high degree of symmetry and strong interparticle coupling, has received extensive attention from the community of functional material synthesis. Such structure constructed in the nanoscale using gold nanoparticles has broad applicability due to its tunable collective plasmon resonances, while the synthetic process with precise control of the morphology is critical in realizing its target functions. Here, we demonstrate a synthetic strategy of seed-mediated space-confined self-assembly using the virus-like silica (V-SiO2) nanoparticles as the templates, which can yield gold nanoraspberries (AuNRbs) with uniform size and controllable morphology. The spikes on V-SiO2 templates serve dual functions of providing more growth sites for gold nanoseeds and activating the space-confined effect for gold nanoparticles. AuNRbs with wide-range tunability of plasmon resonances from the visible to near infrared (NIR) region have been successfully synthesized, and how their geometric configurations affect their optical properties is thoroughly discussed. The close-packed AuNRbs have also demonstrated huge potential in Raman sensing due to their abundant “built-in” hotspots. This strategy offers a new route towards synthesizing high-quality AuNRbs with the capability of engineering the morphology to achieve target functions, which is highly desirable for a large number of applications.