Hongwei Yang

Hongwei Yang


Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 December 2019 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
GZGuopeng ZHAO
Guopeng ZHAO
HYHongwei Yang
Hongwei Yang
JCJiang Chao
Jiang Chao
Microgrids should go into islanding operations to supply power for local critical loads in the event of grid faults. During the operation of the microgrid, the voltage of the point of common coupling (PCC) can be maintained within a certain range by energy storage equipment (ESE). In this work, a direct seamless transfer strategy is developed based on the design of the power and inductor parameters of the three-phase converter in the ESE. When unintentional islanding occurs, the amplitude and frequency of the PCC voltage is affected by the output voltage of the converter, the rated power of the converter, and the voltage drop across the inductor. To ensure the value of the amplitude and frequency of the PCC voltage within the prescribed range, limiters are added to the modulation waves to realize the direct seamless transfer strategy. By analyzing the vector diagram of voltage and current vectors for different loads, the power requirement of the ESE and the voltage drop across the inductor in the converter are obtained. Finally, the design of the limiters’ parameters, analysis of inductor ripple current, and influence of nonlinear load on the PCC voltage are presented for the proposed control strategy.

2 October 2019 in Electronics
Verified
Journal Article
Open access
PDF file
GZGuopeng ZHAO
Guopeng ZHAO
HYHongwei Yang
Hongwei Yang
The converter in a microgrid uses the active power and reactive power (PQ) control strategy when connected to the grid. In the case of failure of large power grid, the converters are required to be connected in parallel under the condition of island to provide power to the load. In this paper, a new control method for the parallel operation of converters based on V/F control is proposed. The V/F control is used to ensure the output voltages have the same amplitude and frequency, then the converters will only produce circulating current caused by phase angle inconsistency. The phase angle self-synchronization strategy is proposed to make sure the phase angle of output voltage of all converters in the system are consistent. First, a large inductor is added to the end of the converter to ignore the line reactance, through this, the measured voltage at the terminal of the converter roughly equals to the voltage of the load, thus, every converter has the same reference of phase angle. Using the proposed phase angle self-synchronization strategy allows the output voltage of every converter to have the same phase angle, so that there is no circulating current between converters, and the power is evenly distributed among the converters. The simulation verification was carried out on the Power Simulation (PSIM) simulation platform, and the experimental verification was implemented on the hardware experimental platform. Both results demonstrate the effectiveness of the proposed strategy. This method is highly reliable and easy to implement, and the circulating current can be reduced effectively.