Reversal ventilation is one of prevention methods against fire hazard in underground mines, but it is not recommended for the mines where methane is present. The authors introduce the new method of reversal and by conducting numerical simulations they prove that it allows to keep methane at the acceptable level during miners escape. However, it requires connection between the subnetworks of the main ventilation fans. It was also shown, that by using the method some escape routes will be shortened. It is possible to apply this method in the mines where the fans and stoppings are fully controlled across the full range of their operating parameters. The findings are important for underground mines, as well as for surface facilities where air control or smoke control is managed by two or more fans.

This study of the strength and deformation of coal samples was triggered by the need to define the stress–strain characteristics of pillars during room and pillar mining in the shaft protective pillar at the ČSM Mine. It was probably the world’s deepest deployment of this mining method in a coal mine. In order to solve the bearing capacity of pillars, the dependence of coal strength on the slenderness ratio is used. For this reason, coal samples with different slenderness ratios were investigated. After considering the purpose of this research, slenderness ratios (width/height) of 1 to 7.7 were chosen. At the same time, the modulus of deformation as a function of the slenderness ratio was determined, and the vertical deformation of the pillars and the safety factor were calculated. Attention is also paid to the influence of sampling on the results of measured coal strengths.

The further development of coal mining in different countries and in India is connected with many problems. The emission of gas, sudden outbursts of gas and coal, mine fires, dustiness, spontaneous combustion, methane concentration are very serious problems. This article deals with solving these problems. It describes a new method applied in coal mines in the Czech Republic that has brought very good results.

In the Czech Republic, the prevention of rock and gas outbursts is carried out in the course of driving mine workings in seams and in sandstone and conglomerate beds classified into a category with the highest degree of rock and gas outburst hazard. It is a case of active methods that aim at prevention of rock and gas outbursts by creating a protection zone in front of and in sides of mine workings being driven and passive methods that mitigate the effects of outbursts (Hudeček et al., 2009, 2010). In this article, authors present recommendations and proposals for changes in rock and gas outburst prevention. These proposed changes should reflect in increased efficiency in coping with this anomalous geomechanical events.

The article presents the results of research into the influence of the location of auxiliary ventilation devices on the distribution of methane concentrations at the outlet of the longwall in an underground mine. Since this area is crucial from the point of view of explosion risk, the existence of an optimal arrangement of these devices could lead to improved safety of the crew working in the area. The aim of conducted study was to examine if the impact of this devices placement is significant. The research was carried out with the use of computational fluid dynamics (CFD) modeling—Ansys Fluent. The analyses took into account the location of the two most commonly used devices: a brattice and an auxiliary air-duct. The numerical model has been prepared and validated based on in situ measurements. Thirty-two cases of device configurations were analysed. The length and position of the brattice, as well as the height and position air-duct outlet along tailgate, were modified. It has been shown that although the presented solutions are an effective risk mitigation method, contrary to the common opinion of many practitioners, the impact of their exact placement, provided it is compliant with the regulations, is not significant for the registered methane concentration distribution at a longwall outlet.