Zijun Wamg

Mr. Zijun Wamg

orcid

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
24 December 2020 in IEEE Journal of Photovoltaics
Verified
Journal Article
Closed access
GYGenjie Yang
Genjie Yang
ZWZijun Wamg
Zijun Wamg
DZDayong Zhang
Dayong Zhang
XQXiangdong Qin
Xiangdong Qin
JHJiang Huang
Jiang Huang
JYJunsheng Yu
Junsheng Yu
A polyelectrolyte material of ethoxylated polyethylenimine (PEIE) was combined with the conventional electron transport material of [6, 6]-phenyl-C61-butyricacidmethylester (PCBM) as an electron transport layer (ETL), and high-performance perovskite photodetectors (PePDs) consisting of the PEIE:PCBM combination system as the ETL were fabricated. The PEIE:PCBM combined ETL could tune the energy barrier for invert injected hole charges between the interface of ETL and electrode. As a result, the reduced dark current and improved photoresponse of PePDs were realized. The results showed that the obtained devices possessed a high detectivity (D*) of 4.77 × 1012 Jones, which was about three folds higher than that of controlled devices with pristine PCBM ETL. Meanwhile, the PePDs exhibited excellent recovery characteristics in light/dark conversion mode. Through a series of structure, morphology, and photoelectric characterization, the detailed mechanisms for the performance improvement of PePDs are disclosed.

7 April 2021 in IEEE Journal of Photovoltaics
Verified
Journal Article
Closed access
YHYu Huang
Yu Huang
DZDayong Zhang
Dayong Zhang
MWMengge Wu
Mengge Wu
GYGenjie Yang
Genjie Yang
ZWZijun Wamg
Zijun Wamg
JYJunsheng Yu
Junsheng Yu
Perovskite solar cells (PSCs) have attracted a lot of attention due to high efficiency and low-cost fabrication processing. For planar structure PSCs, the electron transport layer (ETL) plays an important role to enhance the electron extraction capacity, device stability and balance the energy level between perovskite materials and metal electrode, which can effectively optimize the performance of PSCs. However, traditional ETL materials are not comfortable for commercialization of PSCs due to their inherent characteristics like strong aggregate, relatively low electrical conductivity, and poor ohmic contact with the metal electrodes. Here, a mixed heterojunction layer (MHL) combined an amphiphilic polymer material of poly[(9, 9-bis(3'-(N, N-dimethylamino)propyl)-2, 7-fluo-rene)-alt-2, 7-(9, 9-dioctylfluorene)] with conventional ETL materials [6, 6] phenyl C61-butyric acid methyl ester (PC 61 BM) was developed to optimize the interface characteristics between perovskite and metal electrode. Atomic force microscopy, the space charge limited current, photoluminescence measurements, and impedance spectroscopy have been measured to reveal the interface contact, electronic, and optical properties of the MHL modified PSCs device. As a result, the power conversion efficiency (PCE) of PSCs with MHL has dramatically increased from 15.17% to 18.39%. More importantly, the stability of the MHL based PSCs was improved significantly, with reduced PCE degradation (from 29% to 18%) after 160 h under ambient conditions. This research provides a simple but effective method to improve the efficiency and stability of PSCs.