This paper is a review of the development of simulation model for water-energy nexus in achieving sustainable water management in Indonesia. It is important to understand complex interconnection of water and energy to create strategy since Indonesia is facing the decrease of resources and increase of demand. A system dynamic simulation model is a reliable tool to simulate the relationship between water and energy. This study objective is to develop a conceptual model that can determine the amount of demand, supply, or import of water and energy. The method used is a Vensim (Ventana Simulation Environment) program. This conceptual water-energy nexus framework could further being tested to calculate the balance of water and energy element and creating sustainable resource management plans.
1 February 2020 in IOP Conference Series: Earth and Environmental Science
The goal of this research is to conduct clash detection analysis using BIM-based software for construction of mid-rise building using the BIM technology. The research method implemented in this study is analysis of clash detection using building information modeling (BIM) software for structural, architectural, and MEP of mid-rise building in Jakarta. The result of this thesis is BIM-based 3D construction modelling, the analysis of clash detection which detected namely 104 clashes within overall models, and the estimate analysis of change in construction cost due to clash resolves with result of nearly 1% change of cost and quantity within structural, and MEP model.
1 April 2021 in IOP Conference Series: Earth and Environmental Science
Monitoring is an important part of project management with the aim of knowing how far the project is running and whether there are obstacles during the project’s running. At present, this monitoring process cannot be done in real-time, and conventional monitoring tends to be expensive and error prone. Unmanned Aerial Vehicle (UAV) is a technology that began to be developed to overcome these problems. The research discussed the use of UAVs for real-time monitoring, with quantitative and qualitative methodologies using primary and secondary data. The results of the research indicate that: (1) UAVs produce 3D photogrammetric that provide more detailed and easier results in real time monitoring, (2) The use of UAV is 35,41% faster, accuracy reaches 71.22%, more economical up to 78%, productivity level of up to 94,48% compared to conventional methods, (3) Limitation of UAV capability in conducting real-time monitoring, including battery power, and not yet waterproof.
1 February 2020 in IOP Conference Series: Earth and Environmental Science
Lots of bridge failure phenomenon caused by scour on pier foundation or abutment. One of the most important factors of the bridge is the abutment. Abutment is a structure, built at the edge of the bridge. Abutment is designed to hold the weight of the bridge and over the bridge. The structure of abutment usually planted in to the river. One of methods to minimize the scour impact is considering the shape and design of abutment. This research aims to find out the effect of abutment model or shape variation (semi-circular end abutment, wing wall abutment and spill through abutment) toward the change of velocity using Flow-3D for numerical modeling, the physical test to validation the flow condition and analyze the characteristic sediment transport pattern using Hjulstörm curve. The result of research state that the spill through abutment is the most effective model to keep the stability of flow velocity around the abutment. Correlation between Froude Number (Fr) with Relative Longitudinal Distance Ratio is discussed in this paper. Then, Hjulstörm curve shows that with bed material diameter (d50) of 0,54 mm, sediment transport in the entire abutment model located at erosion zone.
The Indonesian Regulation which refers to the ICOLD Regulation (International Committee on Large Dam required have the Emergency Action Plan (EAP) guidelines because of the dams have potential failure. In EAP guidelines there is a management of evacuation where the determination of the inundation map based on flood modeling. The purpose of the EAP is to minimize the risk of loss of life and property in downstream which caused by dam failure. This paper will describe about develop flood modeling and inundation map in Krisak dam using numerical methods through dam break analysis (DBA) using hydraulic model Zhong Xing HY-21. The approaches of dam failure simulation are overtopping and piping. Overtopping simulation based on quadrangular, triangular and trapezium fracture. Piping simulation based on cracks of orifice. Using results of DBA, hazard classification of Krisak dam is very high. The nearest village affected dam failure is Singodutan village (distance is 1.45 kilometer from dam) with inundation depth is 1.85 meter. This result can be used by stakeholders such as emergency responders and the community at risk in formulating evacuation procedure.
14 December 2018 in IOP Conference Series: Earth and Environmental Science
The urban drainage model requires spatial data and catchment discretization because of the complexity of system. Using integration of Geometric Information System (GIS) technology and urban storm water models, the performance of urban drainage system can be analysed.[1] Especially in coastal area, the main problem of urban drainage is overloaded capacity because of rapid urbanization and coastal floods caused by storm surges and wave action superimposed on high water levels generated during the cycle of tides. Land use change, watershed area as settlements area, clogged drainage pipe/channel, the changing of imperviousness of land cover also contributes to large volume of surface runoff. Moreover, the developments can change land cover in urban area and increasing rainfall runoff. One of the solutions for coastal urban drainage is by using polder system for flood control. The purpose of this paper is to illustrated how GIS can model the catchment discretization and MIKE URBAN-SWMM (Storm Water Management Model) can analyse water balance based on the rainfall return period of 25, 50 and 100 years. The research shows evaluation result of the polder performance including inundation depth and pump performance by linking GIS between storm water models. The case study is analysing the Pluit polder in Jakarta-Indonesia, which is connected to the Indonesia Central Bank compartment. Based on the model, this polder system can reduce flooding in Indonesia Central Bank Compartment up to 50%, however the inundation is still occurred.