Ethanol is currently one of the most important and attractive sources of energy with a heating value of 12800 kJ/kg. Ethanol is commonly obtained from many sources worldwide, mainly renewable sources, and its separation is achieved typically by atmospheric distillation. Even so, there is new technologies looking for cheaper and more efficient ethanol separation and purification: pressure-swing distillation, extractive distillation, adsorption with molecular sieves and vacuum membrane distillation. The design, rating and optimization of these process technologies requires a reliable and universal thermodynamic modeling approach capable of represents the ethanol-water system properties, and in particular the vapor-liquid equilibrium (VLE) near the azeotropic point. This study summarize VLE experimental data for ethanol-water system at 3 vacuum pressures (13.15, 19.71 and 101.32 kPa), and 17 azeotropic point data. Thermodynamic consistency test of the data was performed using the Redlich-Kister method. The parameters and constants for the detailed thermodynamic modeling of the ethanol-water system using polar fluid Soave-Redlich-Kwong equation of state (polar-SRK) are summarized as part of this study, as well as the standard binary interaction parameters for NRTL and UNIQUAC excess Gibbs energy models. Both models are used simultaneously for the simulations involved in the chemical process engineering activities in science, academy and industry. The main target of this study consist in the regression of new binary interaction parameters in a temperature dependent form compatible with the most process simulation software, for NRTL and UNIQUAC, and its validation using experimental data for azeotropic points at 3 different low pressures with errors of less than 1%, for temperature and ethanol molar fraction in the vapor phase. The regressed new parameters were tested using isobaric experimental data for VLE at the 3 under-atmospheric pressures mentioned, obtaining correlation coefficient (R2) values of about 1. The calculations were performed using Python 3.4® codes developed and supplied by S&S and Aspen properties® V8.6 provided by the Universidad Nacional de Colombia.
28 March 2024 in Renewable and Sustainable Energy Reviews
BRT (Bus Rapid Transport) vehicles are a frequented microenvironment, it consists of exclusive lines for the transport of passengers in articulated buses. In many large cities of developing countries BRT vehicles are diesel operated buses emitting important amounts of PM2.5, a pollutant related with many health affectations. Evidence of high exposure levels have been reported onboard BRT vehicles, but detailed analysis of self-pollutions has not been developed. In this research, measurements of PM2.5 inside the BRT system of Bogota called TransMilenio were performed. Speed and location data were recorded in real-time. In-situ measurements were performed in 3 lines of the system: Av. El Dorado, Av. Caracas and Calle 80, in different seat locations inside the buses. PM2.5 concentrations above 120 µg/m3 were measured for all the cases studied. Values above the 24 h WHO (World Health Organization) recommendation were registered. Trips were determined to be between 20 to 40 minutes per passenger. A CFD (Computational Fluid Dynamics) model was implemented to simulate the exhaust emissions from the buses, 3 traffic velocities of BRT were evaluated: 20, 32 and 60 km/h. Measurements and simulation results were used to calculate the self-pollution ratios inside the vehicles. The rear of the buses was identified as the most polluted section onboard with a ratio of self-pollution about 35% average.
2 December 2022 in Environmental Science and Pollution Research