Biomedical implants are immensely manoeuvered devices that fix various deformities and injuries on medical grounds. With an emergent exploration in this field by researchers, countless combinations of materials have been discovered that perks global mankind. The ultimate goal of this experimentation is to appraise the characteristics of wear and corrosion resistance of Ti–Co–Cr-coated 316L grade austenitic stainless steel (SS) in contrast with TiN-coated and uncoated 316L SS. A micro-abrasion test was conducted on every single sample at 3N, 5N and 7N loads and were characterized in accordance with weight loss, coefficient of friction, surface roughness, Scanning Electron Microscope (SEM) analysis, X-ray Diffraction pattern (XRD), Energy Dispersive X-Ray Analysis (EDAX), Fourier-transform infrared spectroscopy (FTIR) and corrosion resistance. The findings showed that Ti–Co–Cr-coated substrate at 3N load have good mechanical tolerance and offers admirable performance. The corrosion resistance of the specimens divulges the biocompatibility of Ti–Co–Cr as being more distinct because of the existence of titanium metal.
1 January 2013 in International Journal of Surface Science and Engineering
Thermally sprayed coatings that are based on FeSiNiCr-related alloy powders are widely used to improve properties such as the surface hardness, the wear resistance and the corrosion resistance of a variety of coated metal substrate materials. For the current study, the FeSiNiCr-containing coating formulations were thermally sprayed onto a grey cast iron substrate by the high velocity oxy fuel (HVOF) method under controlled conditions. The microstructure and micro abrasive wear performance of both the uncoated substrates and the coated substrates were characterised by optical microscopy as well as by scanning electron microscope (SEM). In addition, X-ray diffraction (XRD) and thermogravimentric analyses (TGA) were undertaken in the partial characterisation of the coating. The densely layered coating had porosity levels that were below 1.5% and a high surface hardness, of the order of 920 HV0.1. The coating exhibited excellent wear resistance when subjected to the ball-cratering test method. The wear rate of coating was significantly less than the wear rate of the substrate. Low coefficients of friction of hard coating on the substrate were recorded. The wear performance of the coating was nearly 80% better than that of the substrate, with a 0.05 N load, even under severe three body abrasive conditions. A tribometer was used to assess the wear testing to evaluate the change in the coefficient of friction and the wear rate with respect to the change in time.
11 June 2024 in Biomass Conversion and Biorefinery
BACKGROUND: This investigation was conducted to encapsulate 316L SS with a Ti-based alloy coating. OBJECTIVE: The aim was to fabricate a coating using TiN, TiO2, and TiCoCr powders on 316L SS through the physical vapor deposition (PVD) sputtering process. METHODS: The powders were consecutively coated on 316L SS through the PVD sputtering process with coating durations of 30, 60, and 90 min. Further microhardness, surface roughness, microabrasion, and adhesion strength tests were also carried out. RESULTS: A 60% improvement in abrasion resistance was observed in TiCoCr-coated samples compared to the uncoated substrate. The X-ray diffraction results confirmed the optimal formation of Ti alloy coatings with corresponding orientation over the SS substrates. Moreover, TiCoCr with a 90 min coating duration had much better surface characteristics than TiO2 and TiN. CONCLUSION: The 90 min coating duration should be optimal for coating in steel for bio-implants.