Ahmad Abdo

Ahmad Abdo


Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
24 January 2020 in Future Internet
Verified
Journal Article
Open access
PDF file
AAAhmad Abdo
Ahmad Abdo
CDClaude D'Amours
Claude D'Amours
We propose an adaptive joint pre- and post-compensation to correct the filtering effects caused by cascading reconfigurable optical add drop multiplexers (ROADMs). The improvement is achieved without using additional hardware (HW) on the link or within the signal processor in the transponders. Using Monte Carlo simulations, the gradient-descent based method shows an improvement of 0.6 dB and 1.1 dB in the required optical signal-to-noise ratio (R-OSNR) at the threshold pre-decoder bit error rate (BER) of 0.02 versus pre-compensation only in the linear and nonlinear operating region of fiber respectively. We experimentally verified the method with lab measurements in the presence of heavy filtering and optical impairments. We observed a gain up to ~0.4 dB compared to typically used pre-compensation only. Additionally, other tangible system benefits of our method are listed and discussed.

3 November 2019 in Journal of Computer Networks and Communications
Verified
Journal Article
Open access
PDF file
AAAhmad Abdo
Ahmad Abdo
CDClaude D’aMours
Claude D’aMours
In this article, we analyze the performance of adaptive filtering in the context of dual-polarization coherent optical flexible bit-rate transceivers. We investigate the ability of different adaptive algorithms to track fast state-of-polarization (SOP) transients in the presence of colored noise. Colored noise exists due to the concatenation of Wavelength Selective Switches (WSSs) and polarization dependent loss (PDL) which can be considered as spatially dependent noise. We consider the use of different modulation formats, and the practical limitation of error signal feedback delay in decision-directed adaptive filters is also taken into account. The back-to-back required signal-to-noise ratio (RSNR) penalty that can be tolerated determines the maximum SOP rate of change that can be tracked by the adaptive filters as well as the filter’s adaptive step size. We show that the recursive least squares algorithm, using the covariance matrix as an aggressive “step size,” has a much better convergence speed compared to the least mean squares (LMS) and normalized LMS (NLMS) algorithms in the presence of colored noise in the fiber. However, the three algorithms have similar tracking capabilities in the absence of colored noise.

25 September 2019 in Future Internet
Verified
Journal Article
Open access
PDF file
AAAhmad Abdo
Ahmad Abdo
SASadok Aouini
Sadok Aouini
BRBilal Riaz
Bilal Riaz
NBNaim Ben-Hamida
Naim Ben-Hamida
CDClaude D'Amours
Claude D'Amours
In this paper, we propose a novel circuit and system to optimize the spacing between optical channels in gridless (also called flexible-grid or elastic) networking. The method will exploit the beginning-of-life link margin by enabling the channel to operate in super-Nyquist dense wavelength division multiplexing mode. We present the work in the context of software-defined networking and high-speed optical flexible-rate transponders. The clock recovery scheme allows the mitigation of jitter by decoupling the contribution of high-jitter noise sources from the clock recovery loop. The method and associated algorithm are experimentally verified where a spectrum gain of up to 2 GHz in spacing between two channels in the Media Channel (MC) is obtained compared to conventional clocking strategies. We showed that the improvement is equivalent to increasing throughput, in a data-center interconnect scenario, by up to 300 giga-bits per second per route.

10 February 2020 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Closed access
AAAhmad Abdo
Ahmad Abdo
SASadok Aouini
Sadok Aouini
NBNaim Ben-Hamida
Naim Ben-Hamida
CDClaude D'Amours
Claude D'Amours
Low-power circuits built into optical transceivers that can be used in characterizing phase interpolators and injecting jitter to test the tolerance of clock-data recovery are presented. The novelty is in digitally controlling a pre-compensated phase interpolator in the feedback path of a phase lock loop. The latter is driving the sampling clock of the digital-to-analog converter at the transmitter. To improve the accuracy of jitter mask measurements at the receiver, the nonlinearity of used phase interpolator is compensated by the mean of a programmable look-up-table, which is populated using a built-in test circuity. As well, the LUT can serve to allow for generating jitter frequencies that are out of phase-locked loop bandwidth. Both linearization and jitter injection methods are generic and can be applied to any wireline transceivers at both client and modem interface sides.

1 October 2019
Verified
Conference Paper
Closed access
AAAhmad Abdo
Ahmad Abdo
SASadok Aouini
Sadok Aouini
NBNaim Ben-Hamida
Naim Ben-Hamida
CDClaude D'Amours
Claude D'Amours