Coal permeability is one of the most critical parameters affecting gas flow behavior during coalbed methane (CBM) production. However, little research has been conducted on how permeability evolves after CO₂ injection in coking coal. Hence, examining possible chemical interactions between coal minerals, water, and injected CO₂ can be very helpful to better characterize coking coal. In this study, coking coal specimens obtained from the Malan and Tunlan mines located in the Gujiao block of the Qinshui basin were treated with water and CO₂ to achieve a better understanding of their dissolution kinetics, pore structure, and permeability. It was found that the relative carbonate mineral content decreases with time, while the relative clay mineral content increases after the reaction with CO₂ and water. Scanning electron microscopy (SEM) confirmed these mineral alteration phenomena. Carbonate minerals (calcite, dolomite) dissolve faster than clay minerals (montmorillonite, illite and kaolinite). In particular, the dissolution rates of Ca²⁺ in carbonate minerals increases with decreasing temperature (25–45 °C) and pH (4.3–6.3), and the dissolution rate of Ca²⁺ ions in the calcite reaction solution is higher than that in the dolomite solution. In addition, the results of low-pressure nitrogen adsorption analysis showed that CO₂ injection can enlarge smaller size pores into larger size pores and change the overall pore size distribution. Therefore, CO₂ injection can increase the porosity of coal beds and ultimately their permeability, which in turn facilitates CBM production.

Coal fires that are induced by natural spontaneous combustion or result from human activities occurring on the surface and in underground coal seams destroy coal resources and cause serious environmental degradation. Thermal infrared image data, which directly measure surface temperature, can be an important tool to map coal fires over large areas. As the first of two parts introducing our coal fire detection method, this paper proposes a self-adaptive threshold-based approach for coal fire detection using ASTER thermal infrared data: the self-adaptive gradient-based thresholding method (SAGBT). This method is based on an assumption that the attenuation of temperature along the coal fire’s boundaries generates considerable numbers of spots with extremely high gradient values. The SAGBT method applied mathematical morphology thinning to skeletonize the potential high gradient buffers into the extremely high gradient lines, which provides a self-adaptive mechanism to generate thresholds according to the thermal spatial patterns of the images. The final threshold was defined as an average temperature value reading from the high temperature buffers (segmented by 1.0 σ from the mean) and along a sequence of extremely high gradient lines (thinned from the potential high gradient buffers and segmented within the lower bounds, ranging from 0.5 σ to 1.5 σ and with an upper bound of 3.2 σ, where σ is the standard deviation), marking the coal fire areas. The SAGBT method used the basic outer boundary of the coal-bearing strata to simply exclude false alarms. The intermediate thresholds reduced the coupling with the temperature and converged by changing the potential high gradient buffers. This simple approach can be economical and accurate in identifying coal fire areas. In addition, it allows for the identification of thresholds using multiple ASTER TIR scenes in a consistent and uniform manner, and supports long-term coal fire change analyses using historical images in local areas. This paper focuses on the introduction of the methodology. Furthermore, an improvement to SAGBT is proposed. In a subsequent paper, subtitled “Part 2, Validation and Sensitivity Analysis,” we address satellite-field simultaneous observations and report comparisons between the retrieved thermal anomalies and field measurements in different aspects to prove that the coal fires are separable by the SAGBT method. These comparisons allowed us to estimate the accuracy and biases of the SAGBT method. As an application of the SAGBT, a relationship between coal fires’ decadal variation and coal production was also examined. Our work documented a total area increase in the beginning of 2003, which correlates with increased mining activities and the rapid increase of energy consumption in China during the decade (2001–2011). Additionally, a decrease in the total coal fire area is consistent with the nationally sponsored fire suppression efforts during 2007–2008. It demonstrated the applicability of SAGBT method for long-term change detection with multi-temporal images.

Coal fires, including both underground and coal waste pile fires, result in large losses of coal resources and emit considerable amounts of greenhouse gases. To estimate the annual intensity of greenhouse gas emissions and the loss of coal resources, estimating the annual loss from fire-influenced coal seams is a feasible approach. This study assumes that the primary cause of coal volume loss is subsurface coal seam fires. The main calculation process is divided into three modules: (1) Coal fire quantity calculations, which use change detection to determine the areas of the different coal fire stages (increase/growth, maintenance/stability and decrease/shrinkage). During every change detections, the amount of coal influenced by fires for these three stages was calculated by multiplying the coal mining residual rate, combustion efficiency, average thickness and average coal intensity. (2) The life cycle estimate is based on remote sensing long-term coal fires monitoring. The life cycles for the three coal fire stages and the corresponding life cycle proportions were calculated; (3) The diurnal burnt rates for different coal fire stages were calculated using the CO₂ emission rates from spontaneous combustion experiments, the coal fire life cycle, life cycle proportions. Then, using the fire-influenced quantity aggregated across the different stages, the diurnal burn rates for the different stages and the time spans between the multi-temporal image pairs used for change detection, we estimated the annual coal loss to be 44.3 × 10³ tons. After correction using a CH₄ emission factor, the CO₂ equivalent emissions resulting from these fires was on the order of 92.7 × 10³ tons. We also discovered that the centers of these coal fires migrated from deeper to shallower parts of the coal seams or traveled in the direction of the coal seam strike. This trend also agrees with the cause of the majority coal fires: spontaneous combustion of coalmine goafs.

Desertification is one of the most critical environmental and socioeconomic issues in the world today. Located in the transitional region between the desert and the Loess Plateau, the Mu Us Sandy Land is one of the nine most environmentally sensitive areas in the world. Remote sensing provides an effective technical method for desertification monitoring. In order to analyze the spatiotemporal distribution of desertification in the Mu Us Sandy Land from 1991 to 2021, the “MSAVI-Albedo” model was employed to extract desertification data in 1991, 2002, 2009 and 2021. The clustering characteristics of desertification were analyzed based on Moran’s I statistic. Subsequently, the driving forces in desertification changes were investigated using a geographical detector to analyze the influence of soil, meteorology, and topography on desertification. Additionally, the impact of meteorological and human factors on desertification change in the Mu Us Sandy Land was assessed. From 1991 to 2021, the degree of desertification of the Mu Us Sandy Land showed an overall decreasing trend, and the percentage of land classified as undergoing extremely severe, severe, moderate and mild desertification was improved by 86.11%, 81.82%, 52.5% and 37.42%, respectively. The proportion of land classified as undergoing extremely severe desertification decreased from 29.22% to 5.62%, and the proportion of land undergoing no desertification increased from 4.16% to 18.33%. At the same time, the desertification center shifted westward, and the desertification distribution showed a clustering trend. It is known that different factors affect the formation and distribution of desertification in the Mu Us Sandy Land in the following order: soil, meteorology, and topography. Over the past 30 years, the mean annual temperature and annual precipitation increased at rates of 0.01871 °C/a and 1.0374 mm/a, respectively, while the mean annual wind speed decreased at a rate of 0.00945 m/s·a. These changes provided more favorable natural conditions for vegetation growth and sand fixation. Human factors, such as economic development, agriculture and animal husbandry practices, and the policy of returning farmland to forest (grassland) also had a significant impact on the desertification process, leading to a year-by-year improvement in the ecological environment of the Mu Us Sandy Land.

Underground coal fires in coal fields endanger the mine surface ecological environment, endanger coal resources, threaten mine safety and workers’ health, and cause geological disasters. The study of methods by which to monitor the laws that determine the way underground coal fires spread is helpful in the safe production of coal and the smooth execution of fire extinguishing projects. Based on night-time ASTER thermal infrared images of 2002, 2003, 2005 and 2007 in Huangbaici and Wuhushan mining areas in the Wuda coalfield, an adaptive-edge-threshold algorithm was used to extract time-series for underground coal fire areas. A method of time-series dynamic analysis for geometric centers of underground coal fire areas was proposed to study the propagation law and development trend of underground coal fires. The results indicate that, due to the effective prevention of the external influences of solar irradiance, topographic relief and land cover, the identification accuracy of coal fires via the use of a night-time ASTER thermal infrared image was higher by 7.70%, 13.19% and 14.51% than that of the daytime Landsat thermal infrared image in terms of producer accuracy, user accuracy and overall accuracy, respectively. The propagation direction of the geometric center of the time-series coal fire areas can be used to represent the propagation direction of underground coal fires. There exists a linear regression relationship between the migration distance of the geometric center of coal fire areas and the variable-area of coal fires in adjacent years, with the correlation coefficient reaching 0.705, which indicates that the migration distance of the geometric center of a coal fire area can be used to represent the intensity variation of underground coal fires. This method can be applied to the analysis of the trends of underground coal fires under both natural conditions and human intervention. The experimental results show that the Wuda underground coal fires spread to the southeast and that the area of the coal fires increased by 0.71 km² during the period of 2002–2003. From 2003 to 2005, Wuda’s underground coal fires spread to the northwest under natural conditions, and the area of coal fires decreased by 0.30 km² due to the closure of some small coal mines. From 2005 to 2007, due to increased mining activities, underground coal fires in Wuda spread to the east, south, west and north, and the area of coal fires increased dramatically by 1.76 km².

The self-adaptive gradient-based thresholding (SAGBT) method is a simple non-interactive coal fire detection approach involving segmentation and a threshold identification algorithm that adapts to the spatial distribution of thermal features over a landscape. SAGBT detects coal fire using multispectral thermal images acquired by the Advanced Spaceborne Thermal Emission and Reflection Radiometer (ASTER) sensor. The method was detailed by our previous work “Self-Adaptive Gradient-Based Thresholding Method for Coal Fire Detection Based on ASTER Data—Part 1, Methodology”. The current study evaluates the performance of SAGBT and validates its results by using ASTER thermal infrared (TIR) images and ground temperature data collected at the Wuda coalfield (China) during satellite overpass. We further analyzed algorithm performance by using nighttime TIR images and images from different seasons. SAGBT-derived fires matched fire spots measured in the field with an average offset of 32.44 m and a matching rate of 70%–85%. Coal fire areas from TIR images generally agreed with coal-related anomalies from visible-near infrared (VNIR) images. Further, high-temperature pixels in the ASTER image matched observed coal fire areas, including the major extreme high-temperature regions derived from field samples. Finally, coal fires detected by daytime and by nighttime images were found to have similar spatial distributions, although fires differ in shape and size. Results included the stratification of our study site into two temperature groups (high and low temperature), using a fire boundary. We conclude that SAGBT can be successfully used for coal fire detection and analysis at our study site.