Temperature distribution is an important process parameter of steel plates during electromagnetic induction heating treatment. This study uses the digital image correlation method to develop an effective non-contact temperature measurement that allows obtaining valuable information about the temperature value of a high temperature steel plate specimen and analyzing its temperature distribution. A principle of thermal radiation temperature measurement based on the color chagre couled device (CCD) technology was introduced. The image processing system encapsulates the image update module, form mode module, image event module and temperature analysis module. The error analysis and temperature calibration were carried out to make sure the error deviation of the measurement system was within a small range. The temperature distribution of B1500HS at high temperature was analyzed by the designed measurement system which was in good agreement with the result from Raynger 3i Plus temperature gun, indicating that the measurement system based on image processing basically meets the requirements of temperature distribution measurement of a high temperature steel plate, and provides an important reference for a high temperature steel plate in non-contact temperature distribution measurement.
Gadolinium aluminate (GdAlO3, GAP) nano whiskers were synthesized by the hydrothermal-solid state method, Fourier-transform infrared (FTIR), X-ray diffraction (XRD), scanning electron microscope (SEM) and thermogravimetry-differential thermal analysis (TG-DTA) were employed to analyze the phase change and the nucleation mechanism of GAP during calcing process. The results show that the precursor of GAP prepared by hydrothermal is (NH4)xGdAl(OH)y(NO3)z·nH2O. When the calcination temperature is higher than 900 °C, the precursor recrystallizes, forming the needle shape GAP under the synergistic effect factors. The best preparation conditions are as follows: ammonia water as mineralizer, pH = 9, calcination temperature 1100 °C and holding time 3 h.
5 January 2024 in Biomass Conversion and Biorefinery
In order to effectively avoid the violent vibration in the process of mechanical processing and to achieve high efficiency and high precision machining of mechanical parts, the improved algorithm of adaptive neuro-fuzzy inference system is used to study the optimization of parameters in the process of side milling of mechanical parts, and an adaptive network structure is formed. It has the learning ability of artificial neural network and the expression ability of “if-then” of fuzzy reasoning system, which is a new prediction and control method. The results validate the applicability of the stability. The machined surface topography is measured and the effect of flutter on the surface topography is analyzed. The three-dimensional stability of milling provides a theoretical basis for the rational selection of milling parameters of mechanical parts, the realization of stable milling and the improvement of processing efficiency. Thus, the relationship between the radial depth of cut, the axial depth of cut and the spindle speed is established, and the contour of material removal rate is obtained. The corresponding spindle speed and radial shear depth are obtained when the material removal rate is maximum. The reasonable selection of machining parameters is carried out in the region near the maximum spindle speed with stability.