We developed and evaluated different textile-based inductive coils for near-field wireless power transmission. The technology uses electromagnetic induction for the contactless transfer of electrical energy. Therefore, we investigated various methods for the attachment of conductive materials on a textile-based material and the production of textile-based coils based on QI standard. Afterwards, the textile-based coils were examined and evaluated due to their specific quality characteristics. This happens by calculating the transmission quality and the maximum efficiency of the system which enables comparison of different coil systems and indicates the transmission efficiency of the systems.
Experts attest the smart textiles market will have high growth potential during the next ten years. Laser soldering is considered to be a good contacting method because it is a contactless process. For this reason, it is intended to investigate the contacting process of printed circuit boards (PCB) to isolated conductive textile strips by means of a ytterbium-doped fiber laser (1064 nm). During the investigation, the copper strands in the textile tape were stripped by the laser and soldered to the PCB without any transport of the textile. Therefore, we investigated different sets of parameters by means of a design of experiment (DoE) for different types of solder pastes. Finally, the joinings were electrically analyzed using a contact resistance test, optically with a REM examination, and mechanically using a peeling test.
The connection between flexible textiles and stiff electronic components has always been structurally weak and a limiting factor in the establishment of smart textiles in our everyday life. This paper focuses on the formation of reliable connections between conductive textiles and conventional litz wires using ultrasonic welding. The paper offers a promising approach to solving this problem. The electrical and mechanical performance of the samples were investigated after 15 and 30 wash-and-dry cycles in a laundry machine. Here the contact resistances and their peeling strength were measured. Furthermore, their connection properties were analysed in microsections. The resistance of the joints increased more than 300%, because the silver-coated wires suffered under the laundry cycles. Meanwhile, the mechanical strength during the peeling test decreased by only about 20% after 15 cycles and remained the same after 30 cycles. The good results obtained in this study suggest that ultrasonic welding offers a useful approach to the connection of textile electronics to conductive wires and to the manufacture of smart textiles.
A suitable connection method to automatically produce E-textiles does not exist. Ultrasonic soldering could be a good solution for that since it works with flux-free solder, which avoids embrittlement of the textile integrated wires. This article describes the detailed process of robot-assisted ultrasonic soldering of e-textiles to printed circuit boards (PCB). The aim is to understand the influencing factors affecting the connection and to determine the corresponding solder parameters. Various test methods are used to evaluate the samples, such as direct optical observation of the microstructure, a peeling tensile test, and a contact resistance measurement. The contact strength increases by reducing the operating temperature and the ultrasonic time. The lower operating temperature and the reduced ultrasonic time cause a more homogeneous metal structure with less defects improving the mechanical strength of the samples.
Despite all the growth forecasts of the smart textiles market, there is no stable automated manufacturing process for attaching classic electronics to textiles. The great amount of manual production steps causes high prices, which slow down market growth. During the production process, the contacting step offers the greatest potential to reduce manual manufacturing steps. For this reason, we have analyzed various contacting methods for electronic parts on conductive yarns that have a high potential for automation. The chosen methods were thermode soldering, insulation–displacement connectors and anisotropic conductive adhesives. In order to ensure reliable mechanical contacting, the samples were tested in a peeling experiment. The examination of the contact resistances took place in the context of a resistance test using four-wire measuring technology.