A method to steer the beam of aperture-type antennas is presented in this paper. Beam steering is achieved by transforming phase of the antenna near field using a pair of totally passive metasurfaces, which are located just above and parallel to the antenna. They are rotated independently or synchronously around the antenna axis. A prototype, with a peak gain of 19.4 dBi, demonstrated experimentally that the beam of a resonant cavity antenna can be steered to any direction within a large conical region (with an apex angle of 102°), with less than 3-dB gain variation, by simply turning the two metasurfaces without moving the antenna at all. Measured gain variation within a 92° cone is only 1.9 dBi. Contrary to conventional mechanical steering methods, such as moving reflector antennas with multiaxis rotary joints, the 3-D volume occupied by this antenna system does not change during beam steering. This advantage, together with its low profile, makes it a strong contender for space-limited applications where beam steering with active devices is not desirable due to cost, nonlinear distortion, limited power handling, sensitivity to temperature variations, radio frequency losses, or associated heating. This beam steering method using near-field phase transformation can also be applied to other aperture-type antennas and arrays with medium-to-high gains.

This paper presents an efficient particle swarm optimization (PSO) algorithm developed to design a near-field time delay equalizer metasurface (TDEM) for the purpose of improving directivity and radiation patterns of classical electromagnetic band gap resonator antennas (ERAs). Triple layers of conductive printed patterns in the metasurface were optimized by the PSO algorithm to systematically design the TDEM. Predicted and measured results show a significant improvement in antenna performance including 9.6 dB enhancement in antenna directivity, lower side lobes and higher gain. The measured directivity of the prototype is 21 dBi and 3 dB bandwidth is 11.8%.

A novel technique to design a low-cost frequency-selective surface (FSS) bandpass filter is presented in this article. Wideband polarization-independent FSS bandpass filters are predominantly made of multiple microwave dielectric substrates or noncommercially available composite materials with or without active components, contributing to a very high manufacturing cost. The presented FSS filter has neither microwave substrates, nor any active devices, while it has a large controllable operational frequency band, which can support all polarizations, due to its symmetrical configuration. To the best of our knowledge, such a polarization-independent wideband bandpass response has never been achieved by any low-cost fully metallic FSS filter. The proposed FSS filter is made of three thin metal sheets composed of an engineered metallic substrate (EMS) and a metallic orthogonal dipole resonator (ODR). The EMS is responsible for ensuring the mechanical integrity of the filter without imposing electromagnetic (EM) restrictions throughout the desired frequency band. The integration of EMS and ODRs realizes a fully controllable wideband bandpass verified thorough circuital and modal analyses. According to the predicted and measured results, the FSS filter has a large bandwidth of around 31%, extending from 8.76 to 11.96 GHz with sharp roll-offs for the normal incidence. Simulated and measured results show a low sensitivity of the FSS filter response to oblique angles of incidence for both TM and TE polarizations.

A novel technique to design a phase-correcting structure (PCS) for an electromagnetic band gap (EBG) resonator antenna (ERA) is presented. The aperture field of a classical ERA has a significantly nonuniform phase distribution, which adversely affects its radiation characteristics. An all-dielectric PCS was designed to transform such a phase distribution to a nearly uniform phase distribution. A prototype designed using proposed technique was fabricated and tested to verify proposed methodology and to validate predicted results. A very good agreement between the predicted and the measured results is noted. Significant increase in antenna performance has been achieved due to this phase correction, including 9-dB improvement in antenna directivity (from 12.3 dBi to 21.6 dBi), lower side lobes, higher gain, and better aperture efficiency. The phase-corrected antenna has a 3-dB directivity bandwidth of 8%.

A continuous beam-steering solution for circularly polarized (CP) radial-line slot array (RLSA) antennas is presented and demonstrated with a fabricated prototype. The solution is based on the near-field meta-steering (NFMS) method, which is implemented through a pair of highly transmitting hybrid metasurfaces (HMs) that are placed above a high-gain CP RLSA antenna in the near-field region. Cells in HMs, unlike conventional metasurfaces (CMs), can provide exact or close to exact phase shift with transmission magnitude larger than −1 dB. This is achieved by combining the nonoverlapping phase ranges of two dramatically different phase-shifting cells. The RLSA is stationary, while the two HMs are rotated to steer the beam in a 2-D (azimuth and elevation) space. The measured results of the prototype demonstrate that the system can steer its beam to a maximum elevation angle of 40.6° with a maximum gain of 30.9 dBic. The axial ratio remained less than 3 dB in the 3 dB beamwidth even when the beam is steered. The height of the system is only 4.5 cm, which is much less than mechanically steered reflector antennas. Unlike electronically steered high-gain antenna arrays, this system requires only few watts of power only when rotating HMs and has zero power consumption when the beam is stationary.

This communication presents a method to enhance the radiation performance of conventional electromagnetic band gap resonator antennas (ERAs) by improving their aperture phase distributions. A low-profile printed planar phase correcting surface (PCS) was designed and fabricated to demonstrate performance enhancement. Measurements of a prototype demonstrated that the PCS significantly enhances the directive radiation properties of ERAs. This includes an 8 dB increase in peak directivity, 60% reduction in 3 dB beamwidth (from 35° to 14°), and a considerable reduction in side lobe levels.