Since the penetration of wind power generation in growing, system operators have an increasing interest in analyzing the impact of wind power on the connected power system. The doubly fed induction generator (DFIG) is generally used in the production of the electric energy and more specifically in wind turbines. Currently, to regulate the active and reactive power exchanged between the machine and the grid. A detail dynamic model of a DFIG-based wind-turbine grid-connected system is presented in the d,q -synchronous reference frame by controlling the machine inverter with the algorithm of control based on vector control concept (with stator flux orientation). The aim of control is to have measured active and reactive powers equal to the reference values. These powers must then be collected. In order to measure only the rotor currents, we can use an indirect control method, with integrating power regulation loop, using a classical PI controller: proportional–integral. In this way, this control is able to limit the machine rotor currents. In another way, an appropriate fitness function is derived to express the time domain evolution of DFIG, with the objective to assure the DFIG continuous operation even under a fault condition and improve at the same time its transient behavior as compared with the indirect control without power loop. The control of our machine is simulated; finally the Simulations results are presented and discussed
This paper focuses on experimented space projects run by universities, offering an effective design process to improve learning methods in space engineering. The approach used for the design of CubeSat Electrical Power System (EPS) will go through estimations, sizing, simulations, PCB design and end with an experimental test procedure for design validation. The main design criteria presented in this paper are low costs and effective reliability. To meet the first criterion, the Commercial-Off-The-Shelf (COTS) components are used during the design, which has become an effective path to put experimental payloads in orbit for minimal cost. In the second criterion, the function of some critical EPS components was replicated, such as circuits used for power maximization and battery charge regulation, by following a suitable algorithm embedded in MCU and hot/cold redundant analog integrated circuits. However, the choice was made on the state of the art of CubeSat components already tested. This approach of working will help new space engineers to think about optimal solutions for the design of the appropriate EPS for a CubeSat university project achievable on a limited budget. Finally, the necessary experiments of the designed EPS were carried out and the results were illustrated in the context below.