To improve the surface wear resistance, plasma nitriding of the prefabricated Cu-Ti films on the C17200 Cu alloy is performed to investigate the effects of the composition of the Cu-Ti films on the microstructure and the mechanical properties of the modified surface. The results firstly showed that obvious microstructure evolution appeared during the thermo-plasma nitriding process, where both the surface morphology of the composed phases and the cross-sectional profiles of the multiphase coatings varied for the three types of films. Small amounts of Ti-N compounds, Be3Ti2Cu, and different types of Cu-Ti intermetallics formed in the multiphase coating after plasma nitriding, which is dependent on the composition of the prefabricated Cu-Ti film. Correspondingly, the surface hardness and the wear resistance of the C17200 Cu substrates were obviously improved, with the obtained adhesive strength of the substrate reaching a satisfactory range.
17 June 2024 in The International Journal of Advanced Manufacturing Technology
To improve the wear resistance and fatigue life of Cu alloys, surface modification by combining the magnetron sputtering of Ti film followed by vacuum thermal diffusion is always applied, where the structure and composition of the fabricated film play a determinant role on the mechanical properties. In the present work, the evolution of the layered structure and the element distribution of the formed multi-phases coating on C17200 Cu alloy are investigated by mathematical calculation based on Fick’s law, and the experimental verification by the thermal diffusion of the gradient Cu-Ti film was undertaken under different temperatures and durations. The results show that the layered structure of the fabricated coating is dependent on the Cu-Ti atom concentration, the increasing time and the temperature, where a single or stratified layer is formed due to the generated Cu-Ti intermetallics for the inter-diffusion between the Cu and Ti atoms. The atom distribution by the proposed simulation method based on Fick’s law corresponds to the experimental results, which can be applied to designing the structure of the modification layer.
To improve the processing efficiency and the surface properties of C61900 Cu alloy, a gradient Cu-Ti film with a Ti/Cu atom ratio of 7:1, 7:4, and 1:2 was pre-fabricated by the unbalanced magnetron sputtering process and then nitrided by thermos plasma nitriding. The phase structure, elemental composition, and morphology of the modified surface were characterized, and the mechanical properties, including the wear resistance and adhesion properties, were examined. Combining calculation by the first principle method with thermodynamic analysis, the microstructural formation and phase composition of the Cu-Ti-N system were investigated to reveal the mechanism of improved wear resistance, which indicated the possible formation of various Cu-Ti intermetallics and Ti-N compounds. The Al in the C61900 Cu substrate also participated in the generation of the AlCu2Ti compound, which is a ductile phase with good hardness and elastic modulus. Based on the results of a mechanical properties test, it was concluded that an optimized layer structure for the multi-phase coating should include Ti-N compounds as the surface layer and Cu-Ti intermetallics as the intermediate layer.