Luisa Andrade

Prof. Luisa Andrade

LEPABE - Laboratory for Process Engineering, Environment, Biotechnology and Energy, University of Porto, Porto, Portugal

Research Focus & Metrics

Academic Career Length

18Years (2009-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 September 2016 in Applied Catalysis B: Environment and Energy
Verified
Journal Article
Open access
Natércia MartinsNatércia Martins
Natércia Martins
JÂJoana Ângelo
Joana Ângelo
AGAna Violeta Girão
Ana Violeta Girão
Tito TrindadeTito Trindade
Tito Trindade
Luisa AndradeLuisa Andrade
Luisa Andrade
Adelio MendesAdelio Mendes
Adelio Mendes

1 June 2017 in Engineering Science and Technology, an International Journal
Verified
Journal Article
Open access
EBEmrah Biyik
Emrah Biyik
MAMustafa Araz
Mustafa Araz
AHArif Hepbasli
Arif Hepbasli
MSMehdi Shahrestani
Mehdi Shahrestani
RYRunming Yao
Runming Yao
YAYusuf Baver Atlı
Yusuf Baver Atlı
Renewable and sustainable energy generation technologies have been in the forefront due to concerns related to environment, energy independence, and high fossil fuel costs. As part of the EU’s 2020 targets, it is aimed to reach a 20% share of renewable energy sources in final energy consumption by 2020, according to EU’s renewable energy directive. Within this context national renewable energy targets were set for each EU country ranging between 10% (for Malta) and 49% (for Sweden). A large share of renewable energy research has been devoted to photovoltaic systems which harness the solar energy to generate electrical power. As an application of the PV technology, building integrated photovoltaic (BIPV) systems have attracted an increasing interest in the past decade, and have been shown as a feasible renewable power generation technology to help buildings partially meet their load. In addition to BIPV, building integrated photovoltaic/thermal systems (BIPV/T) provide a very good potential for integration into the building to supply both electrical and thermal loads. In this study, we comprehensively reviewed the BIPV and BIPVT applications in terms of energy generation amount, nominal power, efficiency, type and performance assessment approaches. The two fundamental research areas in the BIPV and BIPVT systems are observed to be i) improvements on system efficiency by ventilation, hence obtaining a higher yield with lowering the panel temperature ii) new thin film technologies that are well suited for building integration. Several approaches to achieve these objectives are reported in the literature as presented in this paper. It is expected that this comprehensive review will be beneficial to researchers and practitioners involved or interested in the design, analysis, simulation, and performance evaluation, financial development and incentives, new methods and trends of BIPV systems

1 October 2010 in International Journal of Hydrogen Energy
Verified
Journal Article
Closed access
TLTânia Lopes
Tânia Lopes
Luisa AndradeLuisa Andrade
Luisa Andrade
HRHelena Aguilar Ribeiro
Helena Aguilar Ribeiro
Adelio MendesAdelio Mendes
Adelio Mendes

1 November 2013 in Journal of Environmental Management
Verified
Journal Article
Closed access
JÂJoana Ângelo
Joana Ângelo
Luisa AndradeLuisa Andrade
Luisa Andrade
Luis M. MadeiraLuis M. Madeira
Luis M. Madeira
Adelio MendesAdelio Mendes
Adelio Mendes

1 May 2016 in Nano Energy
Verified
Journal Article
Open access
PDPaula Dias
Paula Dias
AVAntónio Vilanova
António Vilanova
TLTânia Lopes
Tânia Lopes
Luisa AndradeLuisa Andrade
Luisa Andrade
Adelio MendesAdelio Mendes
Adelio Mendes
Photoelectrodes that are efficient, highly stable, made from low cost materials and easily prepared using inexpensive techniques are required for commercially viable solar photoelectrochemical (PEC) water-splitting technology. Hematite is one of few materials that is being considered for this application. In this work, bare hematite thin films prepared by spray pyrolysis were systematically optimized following a design of experiments approach. A response surface methodology was applied to factors: (i) sprayed volume of solution; (ii) temperature of the glass substrate during the deposition; and (iii) time gap between sprays and the optimized operating conditions obtained were v=42 mL, T=425 °C and t=35 s. The optimized hematite photoelectrode showed a photocurrent density of ca. 0.94 mA cm−2 at 1.45 VRHE, without dopants or co-catalysts, which is remarkable for a thin film of ca. 19 nm. The stability of this photoelectrode was assessed over 1000 h of PEC operation under 1-sun of simulated sunlight. A record-breaking result was obtained with no evidences of hematite film degradation neither of current density loss. These results open the door to turn PEC cells into a competitive technology in the solar fuel economy.

2 July 2014 in Physical Chemistry Chemical Physics
Verified
Journal Article
Closed access
PDF file
TLTânia Lopes
Tânia Lopes
Luisa AndradeLuisa Andrade
Luisa Andrade
FFFlorian Le Formal
Florian Le Formal
MGMichael Gratzel
Michael Gratzel
KSKevin Sivula
Kevin Sivula
Adelio MendesAdelio Mendes
Adelio Mendes
The electrochemical behavior of α-Fe2O3 photoelectrodes prepared by spray pyrolysis with different thicknesses was examined under dark and illumination conditions. The main charge transport phenomena occurring in the PEC cell photoelectrodes were characterized by electrochemical impedance spectroscopy (EIS) operating under dark conditions. The impedance spectra were fitted to an equivalent electrical circuit model for obtaining relevant information concerning reaction kinetics and charge transfer phenomena occurring at the semiconductor/electrolyte interface. A three-electrode configuration was used to carry out the electrochemical measurements allowing a detailed study concerning the double charged layer at the semiconductor/electrolyte interface that arises under dark conditions. The model parameters determined by EIS were then related to the film thickness to assess the role of electronic conduction in the performance of the cell. Moreover, by correlating the sample thickness differences with their electrochemical impedance spectroscopy response, it was possible to discriminate the two main phenomena occurring on semiconductor/electrolyte interfaces of photoelectrochemical systems under dark conditions: the space charge layer and the electrical double layer.