Paula Dias

Paula Dias

Auto-generated profile, based on publicly available information

Paula Dias

LEPABE, ALiCE, Faculty of Engineering University of Porto Rua Dr. Roberto Frias 4200‐465 Porto Portugal

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 May 2016 in Nano Energy
Verified
Journal Article
Open access
PDPaula Dias
Paula Dias
AVAntónio Vilanova
António Vilanova
TLTânia Lopes
Tânia Lopes
Luisa AndradeLuisa Andrade
Luisa Andrade
Adelio MendesAdelio Mendes
Adelio Mendes
Photoelectrodes that are efficient, highly stable, made from low cost materials and easily prepared using inexpensive techniques are required for commercially viable solar photoelectrochemical (PEC) water-splitting technology. Hematite is one of few materials that is being considered for this application. In this work, bare hematite thin films prepared by spray pyrolysis were systematically optimized following a design of experiments approach. A response surface methodology was applied to factors: (i) sprayed volume of solution; (ii) temperature of the glass substrate during the deposition; and (iii) time gap between sprays and the optimized operating conditions obtained were v=42 mL, T=425 °C and t=35 s. The optimized hematite photoelectrode showed a photocurrent density of ca. 0.94 mA cm−2 at 1.45 VRHE, without dopants or co-catalysts, which is remarkable for a thin film of ca. 19 nm. The stability of this photoelectrode was assessed over 1000 h of PEC operation under 1-sun of simulated sunlight. A record-breaking result was obtained with no evidences of hematite film degradation neither of current density loss. These results open the door to turn PEC cells into a competitive technology in the solar fuel economy.

27 October 2015 in Advanced Energy Materials
Verified
Journal Article
Closed access
PDF file
PDPaula Dias
Paula Dias
MSMarcel Schreier
Marcel Schreier
DTDavid Tilley
David Tilley
JLJingshan Luo
Jingshan Luo
JAJoão Azevedo
João Azevedo
MMMatthew T. Mayer
Matthew T. Mayer

20 January 2016 in Physical Chemistry Chemical Physics
Verified
Journal Article
Closed access
PDF file
PDPaula Dias
Paula Dias
TLTânia Lopes
Tânia Lopes
LMLaura Meda
Laura Meda
Luisa AndradeLuisa Andrade
Luisa Andrade
Adelio MendesAdelio Mendes
Adelio Mendes
The substrate influence on the performance of WO3 photoanodes was studied up to 65 °C. The photocurrent increased with temperature and the onset potential shifted to lower potentials. The best operating conditions were: 45 °C for WO3/FTO and 55 °C for WO3/metal; the recombination rate increased for higher temperatures.

1 February 2020 in Joule
Verified
Journal Article
Closed access
ALAvigail Landman
Avigail Landman
RHRawan Halabi
Rawan Halabi
PDPaula Dias
Paula Dias
HDHen Dotan
Hen Dotan
AMAlex Mehlmann
Alex Mehlmann
ARAvner Rothschild
Avner Rothschild

4 September 2014 in Energy & Environmental Science
Verified
Journal Article
Closed access
PDF file
JAJ. Azevedo
J. Azevedo
LSL. Steier
L. Steier
PDP. Dias
P. Dias
MSMorgan Stefik
Morgan Stefik
Celia SousaCelia Sousa
Celia Sousa
DTDavid Tilley
David Tilley
Given the intermittent nature of solar radiation, the large-scale use of solar energy requires an efficient energy storage solution. So far, the only practical way to store such large amounts of energy is in the form of a chemical energy carrier, i.e., a fuel. Photoelectrochemical (PEC) cells offer the ability to convert solar energy directly into chemical energy in the form of hydrogen. Cuprous oxide (Cu2O) is being investigated for photoelectrochemical solar water splitting since it has a band gap of 2.0 eV with favorable energy band positions for water cleavage; it is abundant and environmentally friendly. A major challenge with Cu2O is its limited chemical stability in aqueous environments. We present a simple and low-cost treatment to create a highly stable photocathode configuration for H2 production, consisting of steam treatment of the multilayer structures. The role of this treatment was investigated and the optimized electrodes have shown photocurrents over −5 mA cm−2 with 90% stability over more than 50 h of light chopping (biased at 0 VRHE in pH 5 electrolyte).

1 September 2014 in Solar Energy Materials and Solar Cells
Verified
Journal Article
Closed access
TLTânia Lopes
Tânia Lopes
PDPaula Dias
Paula Dias
Luisa AndradeLuisa Andrade
Luisa Andrade
Adelio MendesAdelio Mendes
Adelio Mendes