Remote sensing allowed monitoring the reservoir water level by estimating its surface extension. Surface extension has been estimated using different approaches, employing both optical (Landsat 5 TM, Landsat 7 ETM+ SLC-Off, Landsat 8 OLI-TIRS and ASTER images) and Synthetic Aperture Radar (SAR) images (Cosmo SkyMed and TerraSAR-X). Images were characterized by different acquisition modes, geometric and spectral resolutions, allowing the evaluation of alternative and/or complementary techniques. For each kind of image, two techniques have been tested: The first based on an unsupervised classification and suitable to automate the process, the second based on visual matching with contour lines with the aim of fully exploiting the dataset. Their performances were evaluated by comparison with water levels measured in situ (r2 = 0.97 using the unsupervised classification, r2 = 0.95 using visual matching) demonstrating that both techniques are suitable to quantify reservoir surface extension. However ~90% of available images were analyzed using the visual matching method, and just 37 images out of 58 using the other method. The evaluation of the water level from the water surface, using both techniques, could be easily extended to un-gauged reservoirs to manage the variations of the levels during normal operation. In addition, during the period of investigation, the use of Global Navigation Satellite System (GNSS) allowed the estimation of dam displacements. The advantage of using as reference a GNSS permanent station positioned relatively far from the dam, allowed the exclusion of any interaction with the site deformations. By comparing results from both techniques, relationships between the orthogonal displacement component via GNSS, estimated water levels via remote sensing and in situ measurements were investigated. During periods of changing water level (April 2011–September 2011 and October 2011–March 2012), the moving average of displacement time series (middle section on the dam crest) shows a range of variability of ±2 mm. The dam deformation versus reservoir water level behavior differs during the reservoir emptying and filling periods indicating a hysteresis-kind loop.
Future projections provided by climate models suggest that the occurrence of extreme rainfall events will increase and this is evidence that the climate is changing. Because the design of urban drainage systems is based on the statistical analysis of past events, variations in the intensity and frequency of extreme rainfall represent a critical issue for the estimation of rainfall. For this reason, the design criteria of drainage systems should take into account the trends in the past and the future climate changes projections. To this end, a Bayesian procedure was proposed to update the parameters of depth–duration–frequency (DDF) curves to assess the uncertainty related to the estimation of these values, once the evidence of annual maximum rainfall trends was verified. Namely, in the present study, the historical extreme rainfall series with durations of 1, 3, 6, 12 and 24 h for the period of 1950–2008, recorded by the rain gauges located near the Paceco urban area (southern Italy), were analyzed to detect statistically significant trends using the non‐parametric Mann‐Kendall test. Based on the rainfall trends, the parameters of the DDF curves for a five‐year return period were updated to define some climate scenarios. Finally, the implications of the uncertainty related to the DDF parameters estimation on the design of a real urban drainage system was assessed to provide an evaluation of its performance under the assumption of climate change. Results showed that the future increase of annual maximum precipitation in the area of study would affect the analyzed drainage system, which could face more frequent episodes of surcharge.
Knowledge of soil water content plays a key role in water management efforts to improve irrigation efficiency. Among the indirect estimation methods of soil water content via Earth Observation data is the triangle method, used to analyze optical and thermal features because these are primarily controlled by water content within the near-surface evaporation layer and root zone in bare and vegetated soils. Although the soil-vegetation-atmosphere transfer theory describes the ongoing processes, theoretical models reveal limits for operational use. When applying simplified empirical formulations, meteorological forcing could be replaced with alternative variables when the above-canopy temperature is unknown, to mitigate the effects of calibration inaccuracies or to account for the temporal admittance of the soil. However, if applied over a limited area, a characterization of both dry and wet edges could not be properly achieved; thus, a multi-temporal analysis can be exploited to include outer extremes in soil water content. A diachronic empirical approach introduces the need to assume a constancy of other meteorological forcing variables that control thermal features. Airborne images were acquired on a Sicilian vineyard during most of an entire irrigation period (fruit-set to ripening stages, vintage 2008), during which in situ soil water content was measured to set up the triangle method. Within this framework, we tested the triangle method by employing alternative thermal forcing. The results were inaccurate when air temperature at airborne acquisition was employed. Sonic and aerodynamic air temperatures confirmed and partially explained the limits of simultaneous meteorological forcing, and the use of proxy variables improved model accuracy. The analysis indicates that high spatial resolution does not necessarily imply higher accuracies.
Actual evapotranspiration is assessed via surface energy balance at an hourly rate. However, a robust estimation of daily evapotranspiration from hourly values is required. Outcomes of surface energy balance are frequently determined via measures of eddy covariance latent heat flux. Surface energy balance can be applied on images acquired at different times and spatial resolutions. In addition, hourly actual evapotranspiration needs to be integrated at a daily rate for operational uses. Questions arise whether the validation of surface energy balance models can benefit from complementary in situ measures of latent heat flux and sap flow transpiration. Here, validation was driven by image acquisition time, spatial resolution, and temporal integration. Thermal and optical images were collected with a proximity-sensing platform on an olive orchard at different acquisition times. Actual latent heat fluxes from canopy and sap flux at tree trunks were measured with a flux tower and heat dissipation probes. The latent heat fluxes were then further analyzed. A surface energy balance was applied over proximity sensing images re-sampled at different spatial resolutions with resulting latent heat fluxes compared to in situ ones. A time lag was observed and quantified between actual latent heat fluxes from canopy and sap flux at the tree trunk. Results also indicate that a pixel resolution comparable to the average canopy size was suitable for estimating the actual evapotranspiration via a single source surface energy balance model. Images should not be acquired at the beginning or the end of the diurnal period. Findings imply that sap flow transpiration can be used to measure surface energy balance at a daily rate or when images are found at an hourly rate near noon, and the existing time lag between the latent heat flux at the canopy and the sap flow at the trunk does not need to be taken into account.
For a large part of human history, urbanization was focused on two main objectives: defence and resource harvesting. The first objective was always achieved in a broad sense, i.e., defending the population from other humans and from natural events. Focusing on human activities, this defensive approach was also applied to urban drainage, which resulted in a systematic underestimation of the impacts of urbanization on natural systems. Environmental sustainability was introduced in an attempt to mitigate these impacts, as they had the potential to endanger future developments; thus, the possibility that urban floods may be the lesser evil was accepted. Resilience was then introduced to improve not only defence of urban areas but also their ability to recover from negative events, even though physical resilience is not always accompanied by social resilience. This paper attempts to address the philosophy of urban drainage design, introducing the new concept of floodability as an evolution of flood resilience by identifying its requirements and drivers and by using real examples to present the new concept.
The olive tree is one of the most characteristic rainfed trees in the Mediterranean region. Observed and forecasted climate modifications in this region, such as the CO2 concentration and temperature increase and the net radiation, rainfall and wind speed decrease, will likely alter vegetation water stress and modify productivity. In order to simulate how climatic change could alter soil moisture dynamic, biomass growth and fruit productivity, a water-driven crop model has been used in this study. The numerical model, previously calibrated on an olive orchard located in Sicily (Italy) with a satisfactory reproduction of historical olive yield data, has been forced with future climate scenarios generated using a stochastic weather generator and a downscaling procedure of an ensemble of climate model outputs. The stochastic downscaling is carried out using simulations of some General Circulation Models adopted in the fourth Intergovernmental Panel on Climate Change (IPCC) assessment report (4AR) for future scenarios. The outcomes state that climatic forcings driving potential evapotranspiration compensate for each other, resulting in a slight increase of this water demand flux; moreover, the increase of CO2 concentration leads to a potential assimilation increase and, consequently, to an overall productivity increase in spite of the growth of water stress due to the rainfall reduction.