Hybrid joints consist of mechanical connections in which both a traditional mechanical joint (i.e. riveting, clinching, welding) and adhesive bonding coexist in order to obtain a better performance if compared with simple bonded or mechanically connected joints. Several literature works demonstrates how hybrid joining allows to improve strength, stiffness and energy absorption in comparison with simple mechanical or bonded connections. In this work the static strength and, more in deep, the fatigue behaviour of clinched, self-piercing riveted, adhesively bonded, clinch-bonded and self-piercing rivet-bonded single lap joint were experimentally investigated for aluminium adherends. It was observed that the static strength of the clinch-bonded and self-piercing rivet bonded joints was essentially due to the adhesive layer, with small decreases due to the reduction of the bonded area related to the presence of the fastened connection. Concerning the fatigue tests, different results were found, in particular it was detected that hybrid joints performed worse than simple joints (especially as regard to the bonded joints) at low number of cycle, while they performed significantly better for high number of cycle. The evolution of the joints damage was monitored by optical observation and by measuring the compliance; it was found that, in the hybrid joints, the presence of the mechanical fastening significantly reduced the crack growth rate in the adhesive layer, with respect to the one of the simple bonded joints, therefore leading to a higher fatigue life.
1 January 2011 in Journal of Adhesion Science and Technology
A model to predict fatigue crack growth in bonded joints under mixed mode I/II conditions is developed in this work. The model is implemented in the finite element software ABAQUS using the related...
The cohesive zone model (CZM) has found wide acceptance as a tool for the simulation of delamination in composites and debonding in bonded joints and various implementations of the cohesive zone model dedicated to fatigue problems have been proposed in the past decade. In previous works, the authors have developed a model based on cohesive zone to simulate the propagation of fatigue defects where damage acts on cohesive stiffness, with an initial (undamaged) stiffness representative of that of the entire thickness of an adhesive layer. In the case of a stiffness that is order of magnitude higher than the previous one (for instance, in the simulation of the ply-to-ply interface in composites), the model prediction becomes inaccurate. In this work, a new formulation of the model that overcomes this limitation is developed. Finite element simulations have been conducted on a mode I, constant bending (constant G)-loaded double cantilever beam (DCB) joint to assess the response of the new model with respect to the original one for varying initial stiffness K0 and cohesive strength σ0. The results showed that the modified model is robust with respect to changes of two orders of magnitude in initial stiffness and of a factor of two in σ0.
1 October 2020 in International Journal of Adhesion and Adhesives