Amorphous Al2O3 is an attractive material for integrated photonics. Its low losses from the UV till the mid-IR together with the possibility of doping with different rare-earth ions permits the realization of active and passive functionalities in the same chip at the wafer level. In this work, the influence of reactive gas flow during deposition on the optical (i.e., refractive index and propagation losses) and material (i.e., structure of the layer) characteristics of the RF reactive sputtered Al2O3 layers is investigated and a method based on the oxidation state of the sputtering target is proposed to reproducibly achieve low loss optical guiding layers despite the continuous variation of the condition of the target along its lifetime.
Amorphous Al2O3 is an attractive platform for integrated photonics, providing active and passive functionalities. We have developed an integration procedure to create active and passive regions at the same level on one wafer. This fabrication process reduces the number of fabrication steps compared to vertical integration of two materials. The main advantage is that all structures are defined within a single photolithography and etching step and are therefore automatically aligned. As a proof of principle, we demonstrated the luminescence of an active ring resonator with passive bus waveguide.
We propose and experimentally demonstrate a modular microring laser (MML) cavity for sensing applications. The proposed MML permits much more design freedom compared with a traditional simple ring cavity by decoupling the performance parameters into several regions in the cavity. Thus, the different biosensor performance parameters can be optimized semi-independently limiting the need for trade-offs on the design of the biosensing device. The first generation MML has been fabricated and tested. A fiber-to-fiber slope efficiency of up to 1.2%, a temperature coefficient of 1.35 GHz/K and a 3σ limit of detection (LOD) of 3.1 × 10−7 RIU without averaging and 6.0 × 10−8 RIU with a 60 s averaging, has been measured for the MML sensor, which is a record-low LOD in on-chip ring cavity optical sensors. Further optimization is possible, capitalizing on the key advantage of the MML concept, namely the potential for designing the laser cavity to achieve the desired optimization goals.
Rare-earth ion doped potassium yttrium double tungstate, RE:KY(WO4)2, is a promising candidate for small, power-efficient, on-chip lasers and amplifiers. There are two major bottlenecks that complicate the realization of such devices. Firstly, the anisotropic thermal expansion coefficient of KY(WO4)2 makes it challenging to integrate the crystal on glass substrates. Secondly, the crystal layer has to be, for example, <1 µm to obtain single mode, high refractive index contrast waveguides operating at 1550 nm. In this work, different adhesives and bonding techniques in combination with several types of glass substrates are investigated. An optimal bonding process will enable further processing towards the manufacturing of integrated active optical KY(WO4)2 devices.
Rare-earth ion-doped potassium yttrium double tungstate, RE:KY(WO4)2, is a promising candidate for small, power-efficient, on-chip lasers and amplifiers. Thin KY(WO4)2-on-glass layers with thicknesses ranging between 0.9 and 1.6 μm are required to realize on-chip lasers based on high refractive index contrast waveguides operating between 1.55 and 3.00 µm. The crystalline nature of KY(WO4)2 makes the growth of thin, defect-free layers on amorphous glass substrates impossible. Heterogeneous integration is one of the promising approaches to achieve thin KY(WO4)2-on-glass layers. In this process, crystal samples, with a thickness of 1 mm, are bonded onto a glass substrate and thinned down with an extensive lapping and polishing procedure to the desired final thickness. In this study, a lapping and polishing process for KY(WO4)2 was developed toward the realization of integrated active optical devices in this material.