Fissured expansive soils were widely distributed in the South-to-North Water Transfer Project. Most of the fissures were filled with clay, which controlled the stability of the slope. With the method of layered filling—bevel cutting—refilling and a modular design idea, the sample with a filled fissure preparation device for triaxial test was designed. After setting the filled fissures of gray-green clay in the expansive soil, triaxial tests were carried out for the samples with no filled fissures and with filled fissures with inclination angles of 15°, 30°, and 45°. Then, considering the spatial distribution and the strength of the filled fissures in the slope, the stability analysis method for the expansive soil slope with filled fissures was proposed. The stability of a typical slope in Nanyang was analyzed. The results show that the c of expansive soil with filled fissures was about 12 to 15 kPa and the φ was 3° to 6°. Filled fissures had an attenuation effect on the strength of the expansive soil. The larger the inclination of filled fissures, the more significant the effect of soil strength attenuation. The fissured slope stability was controlled by the filled fissures. The sliding surface was affected by the vertical fissures on the top of the slope and the slow-inclined long-large fissures in the slope, and the shape of the sliding surface was a broken line, which was basically consistent with the actual landslide.

The principle of effective stress is the most fundamental and important principle in soil mechanics. It serves as the foundation of modern soil mechanics. This paper starts with a discussion of effective stress expressions for unsaturated soils. The relationship between the total stress and stress of each phase in unsaturated soils is developed based on three-phase equilibrium equations of a representative element volume (REV). The expression of average soil skeleton stress, defined as effective stress, for unsaturated soils is then derived. This expression is consistent with the effective stress equation in unsaturated soils derived based on deformation work in the energy conservation equation. The general philosophy for the definition of effective stress in unsaturated soils is pointed out, followed by the discussion of some fundamental problems of unsaturated soils, including effective stress, choice of stress state, capillary phenomenon, and so on. The limitations and application scope of the...

Using prestressed anchor cables is one of the most common approaches for reinforcing slopes. By establishing a calculation model for a high and steep slope, the changes of displacement of slope foot and increment of force on the cables under different prestresses were calculated. Furthermore, the influence of prestress on the changes of displacement of slope foot and force on the cables was analysed. By analysing the changes in force on cables in different parts of the slope, the reinforcement mechanism of a prestressed anchor cable on the slope was attained. The result showed that the reinforcement effect of prestressed anchor cable on the slope was mainly attributed to it effectively restricting the displacement of sliding mass in the slope, while the effect of cables in the lower part of the slope was more significant than that of those in the upper part of the slope. Therefore, to reduce the number of cables, decrease the construction difficulty of cables and save money, it is feasible to remove cables in the range of the upper-third of the slope. Afterwards, by improving the cable prestress in the range of the lower-third and reducing the cable prestress in the middle, the safety factor of the slope can satisfy design requirements, thus reinforcing the slope.

The dynamic strength and accumulated plastic strain are two important parameters for evaluating the dynamic response of soil. As a special clay, the remolded red clay is often used as the high speed railway subgrade filling, but studies on its dynamic characteristics are few. For a thorough analysis of the suitability of the remolded red clay as the subgrade filling, a series of long-term cyclic load triaxial test under different load histories are carried out. Considering the influence of compactness, confining pressure, consolidation ratio, vibration frequency and dynamic load to the remolded red clay dynamic property, the tests obtain the development curves of the dynamic strength and accumulated plastic strain under different test conditions. Then, through curve fitting method, two different hyperbolic models respectively for the dynamic strength and accumulated plastic strain are built, which can match the test datum well. By applying the dynamic strength model, the critical dynamic strength of the remolded red clay are gained. Meanwhile, for providing basic datum and reference for relevant projects, all key parameters for the dynamic strength and accumulated plastic strain of the remolded red clay are given in the paper