The bubbly flow and mixing conditions for gas stirring in a 50t ladle were investigated by using physical modelling and mathematical modelling. In the physical modelling, the effect of the porous plugs’ configurations on the tracer homogenization was studied by using a saturated NaCl solution to predict the mixing time and a color dye to show the mixing pattern. In the mathematical modelling, the Euler–Lagrange model and species transport model were used to predict the flow pattern and tracer homogenization, respectively. The results show that, for a ±5% homogenization degree, the mixing time with dual plugs using a radial angle of 180° is shortest. In addition, the mixing time using a radial angle of 135° decreases the most with an increased flow rate. The flow pattern and mixing conditions predicted by mathematical modelling agree well with the result of the physical modelling. For a ±1% homogenization degree, the influence of the tracer’s natural convection on its homogenization pattern cannot be neglected. This is especially true for a ‘soft bubbling’ case using a low gas flow rate. Overall, it is recommended that large radial angles in the range of 135°~180° are chosen for gas stirring in the present study when using dual porous plugs.
20 June 2019 in Ironmaking & Steelmaking: Processes, Products and Applications
Effect of a swirling flow SEN (submerged entry nozzle) outlet design on the multiphase flow and heat transfer in a mould was investigated by using numerical simulation. It was found that different SEN outlet designs could form different flow patterns and temperature distributions on the upper of the mould. The enlarged outlet SEN design had an effect to decrease the horizontal velocity of liquid steel flowing out the SEN outlet, reducing the steel flow velocity towards the solidification front. Although a higher velocity was found near the slag/steel interface with the enlarged outlet SEN, but the turbulent kinetic energy was lower. The reason was that less circulation flows were formed in the region of the mould top. The weak horizontal flow towards the solidification front with the enlarged outlet SEN induced lower wall shear stresses, at the same time it also formed a lower temperature distribution near the solidified shell.
4 September 2015 in Metallurgical and Materials Transactions B
The swirling flow has widely been investigated for liquid steel flowing in the continuous casting process. In this paper, a new design of the submerged entry nozzle (SEN) is applied by using a reverse TurboSwirl device with a divergent nozzle. This divergent reverse TurboSwirl nozzle (DRTSN) is shown to gain a more beneficial flow pattern compared to the straight nozzle. A stronger swirling flow can be obtained at the SEN outlet, which leads to a calmer flow field and an appropriately active meniscus flow that could improve the heat and mass transfer near the meniscus. The swirl number in the SEN is independent of the casting speed, while a lower casting speed yields a lower maximum wall shear stress. The DRTSN is connected to the tundish by an elbow and a horizontal runner. A longer horizontal runner supplies a more uniform velocity profile and a more symmetrical flow pattern.
28 February 2023 in IEEE Transactions on Antennas and Propagation
We present an accurate and robust surface integral equation (SIE) method for electromagnetic analysis of large-scale plasma media with large negative permittivity. To accelerate the matrix-vector multiplication (MVM) in the iterative solution of the matrix equation, the multilevel fast multipole algorithm (MLFMA) is generally preferred. Traditional implementation of MLFMA will lead to inaccurate results or poor convergence due to the numerical instability arising from the large negative permittivity. To tackle this problem, we analyze the formula of MLFMA in detail and propose a simple and efficient truncation strategy to improve its robustness. A practical and elegant truncation bound is derived based on the ratios of matrix elements between an ordinary permittivity background medium and the negative permittivity plasma. Applying the proposed truncation strategy, the performance of several commonly used SIE formulations is investigated comprehensively. Numerical results demonstrate that the proposed method can avoid numerical instability while maintaining high efficiency for large-scale plasma media with large negative permittivity.