The optical properties of multilayer quantum dots (QDs) with different GaAs barrier thicknesses have been investigated. The photoluminescence (PL) intensity is found to increase with increasing GaAs barrier thickness. For thicknesses larger than the PL intensity increases linearly with the number of the QD layers, with a considerable narrowing of the full width at half maximum (from for active regions consisting of three QD layers). This growth protocol has been applied to laser structures containing stacked QD layers. The broad area processed devices exhibit a modal gain as high as 30 and for structures embedding five and seven QD layers, respectively, which corresponds to per QD layer. The internal quantum efficiency and the transparency current density per QD layer were approximately 70% and , respectively, for both structures.
13 December 2024 in Results in Surfaces and Interfaces
The authors have recently demonstrated the enhancement of the quantum dot laser modal gain, linearly scaling with the number of stacked QD layers. These results allowed the achievement of multi-quantum dot (MQD) lasers, the zero-dimensional counterpart of MQW lasers, with a modal gain as high as 42 cm(-1), in a seven-layer structure. A detailed investigation of the structural and optical properties was performed on laser structures with three, five and seven QD layers. Such an investigation clearly shows that the high uniformity of QD layer features is responsible for the linear increase of the modal gain and its high value.
The electrical and optical properties of InGaN-GaN light-emitting diodes (LEDs) emitting in the 400-500-nm range and having a v-shaped quantum well (VSQW) and a u-shaped quantum well (USQW) are numerically investigated using APSYS simulation program. The simulation results showed that the devices containing VSQW have superior performance in terms of optical power and internal quantum efficiency droop compared to those with USQW. The optical power of the LEDs containing USQW increases gradually and reaches a maximum at 460 nm; however, the optical power of the LEDs with VSQW improves gradually, and the maximum is obtained in a window from 420 to 436 nm as a result of radiative recombination enhancement. The simulation results suggest that the higher performance of the VSQW is due to piezoelectric field reduction and an enhancement of electron and hole wave functions overlap.
In this work, we demonstrate the use of a digitally alloyed GaAsSb as a strain reducing layer (SRL) to tune the optical properties of InAs quantum dots grown on GaAs substrates. The GaAsSb digital alloy was made using a short period GaAs/GaSb superlattice. Increasing the Sb-shutter duty cycle (Sb-SDC) from 0 to 0.35 redshifts the emission wavelength from 1220 nm to 1492 nm at 300 K. The wavelength red shift is attributed mainly to the increased Sb content in the GaAsSb SRL as confirmed by high resolution X-ray diffraction. Power dependent photoluminescence showed a type II band alignment for the samples grown with a Sb-SDC of 0.25 and 0.35. Reversing the growth order of GaAs and GaSb layers and maintaining the same Sb-SDC (0.25) drastically alters the optical properties of the QDs. A large wavelength blue shift of 143 nm and a transformation from a type II to type I emission were observed as a result of GaSb intermixing with InAs QDs.