Despite positive advantages of steel fibers/chips in concrete, there are some drawbacks, such as decreasing workability, which restricts fiber contents, and the impossibility of fibers orientation management in the optimum direction. This study addresses these issues using an alternating magnetic field (AMF). Compression experiments are conducted on cubic fine-aggregate steel chip–reinforced concrete (SCRC) specimens An AMF of 0.5 Tesla (T) and 50 Hz is applied to either fresh SCRC in different directions or to hardened SCRC. The test setup is capable of magnetizing and compressing specimens simultaneously. Applying an AMF to ready-mixed SCRC facilitates the compaction process of concrete and affects compressive strength, depending on exposure direction; exposure in the optimum direction increases compressive strength more than 17%. Moreover, subjecting hardened SCRC to an AMF decreases its compressive strength by approximately 11%. Finally, the advantages of this technique in the concrete industry and the feasibility of developing this method for real-time behavior controlling of smart structures are discussed.
Cement production is one of the major pollution contributors owing to its large rates of energy consumption and gas emission. Moreover, high temperatures could detrimentally impact the concrete infrastructure and thus, it would be essential to study performance of such structures under exposure to the elevated temperatures. In this paper, post-heat performance of the concrete whose cement has been added by zeolite and bentonite at ratios of 6 and 10% (by cement weight) under exposure to temperatures of 28, 150, 300 and 700 °C, was studied. Based on the results, replacing cement by zeolite and bentonite at the age of 90 days under ambient temperature, increases the compressive strength compared to the control specimen. Moreover, it was observed that heating the cubic and cylindrical specimens containing 10% bentonite at 150 °C, increase the compressive strength by 40%. Conversely, the results indicate that when exposed to temperatures of 300 and 700 °C, a decreasing trend is seen in the tensile strength of both cubic and cylindrical specimens containing the pozzolans. Peak intensity of C–S–H has dropped as per rise in temperature from 28 to 700 °C. These values reveal that peak intensity of C–S–H up to 300 °C, is approximately the same but under 700 °C, it has reduced considerably. In all the cubic and cylindrical specimens, it can be seen that the specimens heated at 150° have the highest compressive strength and the specimens heated at 700 °C have the lowest compressive strength compared to the same unheated specimens. The XRD patterns at 150 and 300 °C, reveal decrease and increase in the Portlandite content the difference between conversion ratio of the cubic and cylindrical specimens in this study, to the values provided by the codes, is less than 10%.
13 November 2024 in Measurement Science and Technology
The use of concrete-filled steel tube (CFST) composite columns is increasingly prevalent in the construction industry, particularly in high-rise structures. A common issue in CFST columns is interface debonding between the concrete core and the steel tube. If this debonding progresses both superficially and deeply, it can lead to instability and buckling of the column, posing a serious threat to the overall structural integrity. This study presents an innovative and effective method for extracting damage-sensitive features using horizontal, vertical, and diagonal detail coefficients derived from the wavelet analysis of corrected modal signals. The study introduces the total normalized irregularity detection index (NIDIT) as a damage detection metric. The results indicate that NIDIT is highly effective in identifying and detecting debonding regions. NIDIT quantifies the accumulation of irregularities and disturbances in the affected areas, allowing for the detection of concrete surface debonding from the steel tube. The findings show that NIDIT can accurately and efficiently detect damage in middle and end-edge regions, addressing a significant challenge in structural health monitoring with high precision.