One of the major challenges preventing the concentrated solar power (CSP) industry from occupying a greater portion of the world's energy portfolio are unattractive start up and operating costs for developers and investors. In order to overcome these reservations, plant designers must be able to achieve greater efficiencies of power production. Molten salt nitrates are ideal candidates for CSP heat transfer fluids and have been proposed to offer significant performance advantages over current silicone based oil heat transfer fluids. Ternary molten salt nitrates offer high operating temperatures while maintaining low freezing temperatures. However, a shortage of important thermophysical property data exists for these salts. Previous work has shown the ternary compositions of LiNO3–NaNO3–KNO3 salts offer the widest possible temperature range for use in a CSP system. The present work contains data for the viscosity, specific heat, and latent heat of some mixtures of these salts at various temperatures, providing vital information for plant designers to optimize power generation and attract future investment to CSP systems.
7 January 2013 in Journal of Solar Energy Engineering
Current heat transfer fluids for concentrated solar power applications are limited by their high temperature stability. Other fluids that are capable of operating at high temperatures have very high melting points. The present work is aimed at characterizing potential solar heat transfer fluid candidates that are likely to be thermally stable (up to 500 °C) with a lower melting point (∼100 °C). Binary and ternary mixtures of nitrates have the potential for being such heat transfer fluids. To characterize such eutectic media, both experimental measurements and analytical methods resulting in phase diagrams and other properties of the fluids are essential. Solidus and liquidus data have been determined using a differential scanning calorimeter over the range the compositions for each salt system and mathematical models have been derived using Gibbs Energy minimization. The Gibbs models presented in this paper sufficiently fit the experimental results as well as providing accurate predictions of the eutectic compositions and temperatures for each system. The methods developed here are expected to have broader implications in the identification of optimizing new heat transfer fluids for a wide range of applications, including solar thermal power systems.
1 July 2018 in Journal of Geotechnical and Geoenvironmental Engineering
Thermoactive geostructures (such as energy piles) are used for heating and cooling of buildings, which generate daily temperature changes and cycles in the geostructure and surrounding soil due to the intermittent operation of ground-source heat pumps. For energy piles, daily temperature changes and cycles result in cyclic displacement (expansion and contraction) in both the axial and radial directions of the pile and alter soil properties. In this study, a fully automated modified thermal borehole shear test (modified-TBST) device was utilized to perform tests in normally consolidated clayey soil to investigate the effects of temperature cycles (TC) and radial expansion/contraction displacement cycles (RDC) on the soil-energy pile interaction. In addition to directly measuring the shear stress–vertical displacement curves (t-z curves), the soil temperature at different locations and pore pressure were monitored. The fully automated modified-TBST device uses two concrete plates to simulate the pile surface with temperature and expansion/contraction controls. The tests were conducted with temperature changes ( ) at the soil–concrete interface of , 0, and . The radial expansion and contraction displacements ( ) were and , respectively. Tests were conducted at different interface horizontal normal stresses and numbers of cycles. This paper focuses on summarizing the results of 16 tests: 6 conducted with temperature changes and cycles, 8 with radial displacement change and cycles only, and 4 with combined temperature and displacement cycles. When the soil–concrete interface was subjected to combined radial displacement and temperature cycles, the interface shear strength experienced significant changes. Therefore, it was concluded that the intermittent operation of heat pumps connected to energy piles installed in normally consolidated clayey soils has a significant effect on shaft resistance.